ragingbull Posted May 5, 2015 Share Posted May 5, 2015 It broke at the weld on normal driving. I can re weld or does anyone recommend anything else? Link to comment Share on other sites More sharing options...
turbosubarubrat Posted May 5, 2015 Share Posted May 5, 2015 It broke from the bad angle it was put at because of the lift and not being modded to accommodate the difference in geometry. 1 Link to comment Share on other sites More sharing options...
coxy Posted May 5, 2015 Share Posted May 5, 2015 Weld some reinforcedd channel section on the longer part mounted to the body and then replace the shorter part that goes through the rubbers with a Rod end and bolt the U bracket through the rod end with spacers allowing it torotate while still acting as a stopper. That will never fail again if done properly and it's not that big of a fabrication job. Link to comment Share on other sites More sharing options...
ragingbull Posted May 5, 2015 Author Share Posted May 5, 2015 Sounds good! Thanks gents! Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now