lstevens76 Posted May 15, 2015 Share Posted May 15, 2015 (edited) Ok, I've been into engines before and these pistons/cylinder walls look ok to me but I always like a second opinion. So, if a few people could look over these pictures and give me a second opinion I would appreciate it. And yes there are a lot of pictures, yes there's a nice carbon buildup. This is passenger side only. I'll take pictures of the drivers side later. Edited May 15, 2015 by lstevens76 Link to comment Share on other sites More sharing options...
shoebee2 Posted May 15, 2015 Share Posted May 15, 2015 They look good to me. No pits or heat scars. Crosshatch is still visible and evenly degraded. Run it. 1 Link to comment Share on other sites More sharing options...
Fairtax4me Posted May 15, 2015 Share Posted May 15, 2015 Looks fine to me. Link to comment Share on other sites More sharing options...
Crazyeights Posted May 16, 2015 Share Posted May 16, 2015 Looks good to me too. Link to comment Share on other sites More sharing options...
Fairtax4me Posted May 16, 2015 Share Posted May 16, 2015 This should make you feel better. This engine is still in daily use. Burns about a quart of oil between changes. 1 Link to comment Share on other sites More sharing options...
lstevens76 Posted May 16, 2015 Author Share Posted May 16, 2015 If I saw that I would either pick up a good short block (used) or start a lower end rebuild. lol Here's the driver's side: This also gives me an easy way to look at them. lol The lighting in my garage kind of sucks. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now