comatosellama Posted August 12, 2015 Share Posted August 12, 2015 So.. This has been an issue for a while, i thought replacing the u joints would fix it, not the case. No matter what, when I go into FWD my car just starts rattling and shaking like something is skipping over gears. ANyone ever had this happen? It seemed to be completely out of the blue. The engine has had this problem since I bought it, when I floor it from idle it will almost die, then come back to life. If in gear it sometimes will actually die. I have replaced plugs, wires, carb and both fuel filters. Any ideas? Link to comment Share on other sites More sharing options...
bratman2 Posted August 12, 2015 Share Posted August 12, 2015 Could your front hub splines be stripped? Is your axle nuts torqued down properly? Link to comment Share on other sites More sharing options...
comatosellama Posted August 13, 2015 Author Share Posted August 13, 2015 Everything is looking good up front, tore it apart and put it back together, still does it Link to comment Share on other sites More sharing options...
jono Posted August 13, 2015 Share Posted August 13, 2015 you say FWD - you mean FRont wheel drive or four wheel drive ? so , it does it only in front wheel drive, but if you select four wheel drive it behaves fine ? signed, partially confused Link to comment Share on other sites More sharing options...
comatosellama Posted September 10, 2015 Author Share Posted September 10, 2015 Turned out the problem was a non reman axle. I think the bearing cage fell apart because the cup spins, but not the axle, and creates a very bad grinding noise. When I went into 4wd I think the push from the welded rear diff made it so the front right wasn't engaged much. It still happened in 4wd but much more rare. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now