HUAWEI3054 Posted August 11, 2018 Share Posted August 11, 2018 COULD BE THE MAP SENSOR NEEDS CLEANING OR THE OXYGEN SENSOR NEEDS REPLACEING AND SOME TIMES THE TEMP SWITCH QUIT AND THE COMPUTER WON,T WORK RIGHT .. MAP SENSOR CAN BE CLEANED BUT OTHERS NEEDS REPLACED Link to comment Share on other sites More sharing options...
pbilt Posted September 12, 2018 Share Posted September 12, 2018 Check timing belts could have jumped its a long shot. check if its arching anywhere start it up at night and look around a spray bottle will help if you can' see any arching Link to comment Share on other sites More sharing options...
Espey16 Posted November 5, 2018 Share Posted November 5, 2018 On 8/7/2018 at 3:49 PM, czny said: Found this while reading today: I found the tps in this post for about $260 at autozone. So just to be sure I'll be doing this right, I need to de-solder the stock connector on the harness. Then clip the square connection off the sensor, and solder the wires from the connector to the stock harness? Link to comment Share on other sites More sharing options...
Espey16 Posted November 7, 2018 Share Posted November 7, 2018 I bought that tps, itll be here by 3 today. After I get it soldered on and figure out how to adjust it I'll report back. Link to comment Share on other sites More sharing options...
Espey16 Posted November 8, 2018 Share Posted November 8, 2018 Well that was a success. I cut the connector off the new TPS, and the connector off the stock harness then soldered everything together. The car drove better on my test run than it has the entire time I've had it. The only difference between the 2 was the new TPS has a white wire instead of a green wire like the stock harness has. If anyone is looking for a new TPS, it's part # TPS4085. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now