Bushwick Posted October 20, 2015 Share Posted October 20, 2015 Car has had a noisy "slapping" sound come and go that's appearing a little more now. Only happens when cold, and lasts about 5-10 minutes. Pretty sure it's not a piston issue as it doesn't increase with frequency if you rev it. Had been thinking it was something clanking on the exhaust but started thinking tensioner. Anyone experience a noisy tensioner before? Oil pressure when cold is 75 to 80 psi at idle, so it's happening with cold oil at high psi. Engine runs fine otherwise. Link to comment Share on other sites More sharing options...
idosubaru Posted October 20, 2015 Share Posted October 20, 2015 yes. and i've seen it be loud at start up and then mitigate. pull drivers side timing cover and have a good flashlight handy, see if you can see it flopping around due to loss of hydraulic pressure. 1 Link to comment Share on other sites More sharing options...
Bushwick Posted October 20, 2015 Author Share Posted October 20, 2015 yes. and i've seen it be loud at start up and then mitigate. pull drivers side timing cover and have a good flashlight handy, see if you can see it flopping around due to loss of hydraulic pressure. Any idea what causes it? Is it possibly leaking out and trying to pump back up? I'll try and get the cover off and take a look. Link to comment Share on other sites More sharing options...
Wolfman01 Posted October 21, 2015 Share Posted October 21, 2015 I'd get it replaced post haste. Interference engine. Jump a tooth and you're pulling heads and rebuilding them. It sounds to me like a good time to get in there and replace cam seals, belt, tensioner, idler pullies and anything else that has a bearing or seal attached to it. Link to comment Share on other sites More sharing options...
Bushwick Posted October 21, 2015 Author Share Posted October 21, 2015 I'd get it replaced post haste. Interference engine. Jump a tooth and you're pulling heads and rebuilding them. It sounds to me like a good time to get in there and replace cam seals, belt, tensioner, idler pullies and anything else that has a bearing or seal attached to it. It's a 95' ej22, so non-interference Belt was replaced when I got the car as they couldn't verify how old it was, so it has roughly 15k miles on it. Only leak is the annoying valve cover which had new gaskets installed. Probably should have added a sealant to both sides. I think it's bleeding pressure off while sitting similar to a leaky lifter. Can't get to it now due to some personal issues. Always easy on cold-engine cars, so hopefully it doesn't worsen too much in the next month or so. Link to comment Share on other sites More sharing options...
idosubaru Posted October 21, 2015 Share Posted October 21, 2015 (edited) the hydraulic tensioner gets weak - it's basically like a strut right - so leakage and/or wear over time? Edited October 21, 2015 by grossgary Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now