dp213 Posted February 2, 2016 Share Posted February 2, 2016 I am looking for a possible fix for my stupidity. While putting a new timing belt on a 98 2.2, I stripped the bolt on the bottom timing belt roller. Drilling and tapping it to a 12x1.25 would be easy, but then drilling the roller out would be tricky but doable. Or should I put a helicoil in it to keep it a 10x1.25? Any input would be great. Thanks Link to comment Share on other sites More sharing options...
montana tom Posted February 2, 2016 Share Posted February 2, 2016 I suggest you go with the helicoil, it will help the next guy. 1 Link to comment Share on other sites More sharing options...
DaveT Posted February 2, 2016 Share Posted February 2, 2016 Helicoil or one of the other thread repair inserts. 1 Link to comment Share on other sites More sharing options...
golucky66 Posted February 2, 2016 Share Posted February 2, 2016 Agreed with above posters Link to comment Share on other sites More sharing options...
dp213 Posted February 2, 2016 Author Share Posted February 2, 2016 Thank you everyone. I will get the helicoil tomorrow. Link to comment Share on other sites More sharing options...
Fairtax4me Posted February 2, 2016 Share Posted February 2, 2016 Which idler? The smooth one or the toothed one? The toothed one bolts to the water pump so you can just replace the pump. The smooth one, heli-coil it. Depending on the length of the inserts, you may need to install two inserts so you have plenty of thread engaged in the aluminum to prevent the insert from pulling out of the block. Link to comment Share on other sites More sharing options...
idosubaru Posted February 2, 2016 Share Posted February 2, 2016 i've used longer bolts on timing belt pulleys before, but i can't remember if that was EJ, EA, or ER engines. you can check ahead of time by comparing the length of the bolt (minus the portion that goes through the pulley) to the depth of the hole by inserting a screw driver down there. see how much extra room you got. 1. chase the threads with a tap to clean them up 2. install a longer bolt that will reach unused clean threads in the bottom of the bolt hole. or yeah - just helicoil them. they can be done in place with right angle drills/attachments. put on goggles, place a drill bit in a vice and swing as fast as you can with a heavy hammer - it'll shear the drill bit in half - which may bounce off of 12 different things if you're not prepared for it. this shortens the bit so you can use it in tight places. Link to comment Share on other sites More sharing options...
CNY_Dave Posted February 2, 2016 Share Posted February 2, 2016 Or order short drill bits from mcmaster-carr that show up the next day- love that outfit! Link to comment Share on other sites More sharing options...
dp213 Posted February 3, 2016 Author Share Posted February 3, 2016 Thankfully the motor was out of the car. I did a helicoil today and it worked perfect. Link to comment Share on other sites More sharing options...
CNY_Dave Posted February 3, 2016 Share Posted February 3, 2016 I sweated blood drilling a bolt for my trans extension housing in the car- out is much better! Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now