Disk Brake Tool

[lrgvanman]

Anyone know where to find one of these? It is a Disk Brake Tool for twisting while turning to compress the piston. 

Thanks from Larry G.

[987687]

I just use a pair of pliers or vise grips or something. If the piston is really tight/stuck you have other problems. Undo the bleeder screw so you're just pushing fluid out the caliper, not back into the system. Should make things easier.

[turbosubarubrat]

I just use a grinder wrench that has 2 pins. It works pretty good considering you don't have to change brakes very often. If i want to get fancy i could cut off the head and weld a socket to it to make it go faster with a ratchet. At harbor freight they have a little cube that does the same thing for a 3/8 ratchet not sure if it will work on these or not but they're less than $10.

Edited June 26, 2016 by turbosubarubrat

[Dee2]

I used the cube tool when I was working on my brakes.  It worked well.  I tried to use pliers but didn't have much success.  I found the cube at NAPA.

[lrgvanman]

I recently bought a cube from Knechts Auto Parts but I haven't tried it yet. I have used those in the past. Then there was the elongated version that had the two pokies (spanner) on one end and a hex the other end, difficult to handle while slipping off frequently.

Thanks all from Larry G. 

[MR_Loyale]

I got one at autozone.

[superooo]

Weld some needlenose! Just kidding