iriejedi Posted June 26, 2016 Share Posted June 26, 2016 (edited) I have a 1996 2.2 L engine which I'm currently resealing for a 1998 2.5 Outback engine swap. I was thinking I ought to change the headgaskets while there. No history on the engine, came out of a wrecked Legacy. It's just there is white powder frosting around the drivers side headgasket, back of the topside, rear, and back of the underside. Also an obviously heavy oil pan or oil pump leak. Should I replace these headgaskets based on a hunch or should I run it and find out. The engine only has like 119,000 miles. Also I am curious about the BECK/ARNLEY kits. RockAuto has a special on their full headgasket set kits. Edited June 26, 2016 by iriejedi Link to comment Share on other sites More sharing options...
wtdash Posted June 26, 2016 Share Posted June 26, 2016 (edited) This is a GREAT question......because it's the 'bulletproof' 2.2 and low mileage...but it's an EJxxx engine. I'll be interested to hear others' opinions. I do (most of) my own Subaru repairs and have another car I can drive if needed, so I'd probably just run it as is. If it were the 2.5 I'd definitely change the HG, as they're likely due in the next 10K anyway. :-( I can't advise on the 'white powder'. I'm only a fan of the current OEM HG, so no experience w/the BA kits. FWIW, I just had new rings put in my '96 2.2 due to some smoke @ startup - 128K miles. The Subie tech found a seized/stuck oil ring (likely due to infrequent LOF's - the PO had limited maint. records), which explains the smoke, but otherwise I was told the engine looked clean. P.s. If you have/can get the VIN from the original Legacy you can do a Carfax and if lucky there may be service history. Autocheck may also have it but less likely. Edited June 28, 2016 by wtdash 1 Link to comment Share on other sites More sharing options...
86BRATMAN Posted June 27, 2016 Share Posted June 27, 2016 Felpro ej22e head gaskets are identical to oem. Never see the a B/A gasket, but the felpro has the Fuji logo and ej22 stamped right into the gasket. Link to comment Share on other sites More sharing options...
Fairtax4me Posted June 27, 2016 Share Posted June 27, 2016 Its 20 years old, I would go ahead and put some gaskets on it while it's out just for good measure. Doesn't take much time. The Beck Arnley head gasket kit is a rebadged cheap quality kit. The valve cover seals and intake/exhaust gaskets are ok to use, but the head gaskets are junk. Use Felpro head gaskets. About $25 each. Link to comment Share on other sites More sharing options...
briankk Posted June 28, 2016 Share Posted June 28, 2016 Get the whole FelPro top end kit, quality stuff a fair price. I've done two so far, still holding up, admittedly only 6 months in.. Link to comment Share on other sites More sharing options...
DaveT Posted June 28, 2016 Share Posted June 28, 2016 I have always had good luck with Fel Pro kits for my EA82 engines. [except use only OEM for the intake gaskets] Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now