ferp420 Posted June 8, 2017 Share Posted June 8, 2017 I Would say that intake valve is toast with all the pitting its gona colect carbon and ruin the air flow around the valves at best ive had to many valves in that codition snap on me and take out a piston or a whole motor if it just looks worse than it realy is then clean the isht out of it till it shines then the carbon will have a hard time sticking to it 1 Link to comment Share on other sites More sharing options...
Leone7486 Posted June 9, 2017 Author Share Posted June 9, 2017 Thank you all. How many kilos with dynamometric tool I have to close head please? Link to comment Share on other sites More sharing options...
DaveT Posted June 10, 2017 Share Posted June 10, 2017 Are you asking what the torque on the head bolts should be? Link to comment Share on other sites More sharing options...
Leone7486 Posted June 12, 2017 Author Share Posted June 12, 2017 Many thx. Please, tell me how many kilos I have to close this heads with Dynamomethric tool? Link to comment Share on other sites More sharing options...
Leone7486 Posted June 14, 2017 Author Share Posted June 14, 2017 Yes please Dave T Link to comment Share on other sites More sharing options...
DaveT Posted June 14, 2017 Share Posted June 14, 2017 Step 1 22ft lbs Step 2 43ft lbs Step 3 47ft lbs Be sure to clean the holes and the bolts. Oil the threads. The sequence must be followed also, as shown in the shop manual. There should be links somewhere. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now