jono Posted August 30, 2017 Share Posted August 30, 2017 Does anyone know the correct thread size and type of the larger plug on the EA82 oil pump exterior? Not after the smaller 1\8 inch taller in 28 threads per inch - the other larger one that is about 16 mm across its threads that not appear to be a taper. I have a brass fitting that is about 0.10 mm larger across the threads, looks close but won't screw in. I don't know correct size or thread count of brass fitting at hand. The factory plug has an 8 mm hex in it.thanks for any knowledgeable help???? Link to comment Share on other sites More sharing options...
naru Posted August 30, 2017 Share Posted August 30, 2017 Don`t really know,but,since the pressure switches and senders have BSP format threads,I would expect the plugs to be the same.Sure it isn`t tapered? Link to comment Share on other sites More sharing options...
andrsn Posted August 30, 2017 Share Posted August 30, 2017 I'm currently messing around with putting my ea81 mechanical oil pressure sender unit on an ej engine. My EA81 oil pressure sender has 3/8 BSPT threads. The 3/8 BSPT has 19 threads per inch and is about 5/8" outside diameter. Link to comment Share on other sites More sharing options...
Subaru Scott Posted August 31, 2017 Share Posted August 31, 2017 And yet, it will thread into 3/8" NPT. Just give it a good wrap with teflon tape. Here is my setup, EA pressure senders for gauge and light, (because both is best) T'd into a grease gun hose, running to the 1/8" port in top of the EJ: Been going 4 years now, not a drop. The stainless tie wire is not to hold down, but to ground... cause they won't work if they aint grounded... duh. Link to comment Share on other sites More sharing options...
jono Posted August 31, 2017 Author Share Posted August 31, 2017 Love the ingenuity of the grease gun line! Andsrn....sure it's 19 threads per inch? I always thought the std senders for idiot light etc was 27 tpi but learned they are 28 tpi. My aftermarket Saas brand gauge sender unit uses the coarser 27 tpi taper, so trick is to buy fittings of the finer 28 tpi taper and run a 27 tpi taper tap through it. Works this way but legend has it can't make a finer 28 tpi taper tap through a 27 tpi taper hole. The plug I talk of in first post, thinking it is not taper. I have another ea82 with this port in use. Must investigate a bit more. Thanks guys n gals Link to comment Share on other sites More sharing options...
andrsn Posted August 31, 2017 Share Posted August 31, 2017 The threads of the larger oil pressure sender in the picture (for the mechanical guages) is definetly 19tpi, that's what i was referring to. the smaller one that came on the ej engine is the 27 or 28 tpi. Link to comment Share on other sites More sharing options...
jono Posted September 2, 2017 Author Share Posted September 2, 2017 Thanks. 19 and no taper me thinks Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now