Fozzie Bear Posted September 2, 2017 Share Posted September 2, 2017 (edited) 05 Forester. After an engine rebuild, I have a no start condition. Checked all wires and fuses. All sensors are connected. Plenty of fuel, no spark. Is there a reset procedure? Edited September 2, 2017 by Fozzie Bear Link to comment Share on other sites More sharing options...
Fairtax4me Posted September 2, 2017 Share Posted September 2, 2017 (edited) Check engine light on? Have you scanned it for codes? Double check connectors. Two big connectors on the passenger rear of the engine where the harnesses join. Plug on the ignition coil. ECU Grounds on top of the intake manifold. Crankshaft and camshaft position sensors. Last would be to check the timing belt. Make sure the marks are all correct and hasn't jumped. Did you remove the cam sprockets? If so, Did you make sure to install them back on the correct side? Left sprocket has notches on the back for the cam position sensor to read. If you switch sprockets the sensor doesn't give a signal and you'll get a no-spark condition. Edited September 2, 2017 by Fairtax4me 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now