Knucklehead Saloon Posted October 17, 2017 Share Posted October 17, 2017 (edited) Vehicle is a 91 Brumby. Tried rockauto and cardmon but no dice. Neither had any stock. Are these still available from subaru ? Cheers Richo. Edited October 17, 2017 by Knucklehead Saloon Link to comment Share on other sites More sharing options...
Al Zhiemer Posted October 17, 2017 Share Posted October 17, 2017 Autobarn can usually source them. Protex or Protek brand, not sure of the part number but I can source that for you tomorrow if that helps. Passed through Singleton the day before the big truck incident last week, not sure but I will possibly be down that way for work in the near future. If all else fails I'll let you know if I happen to be passing through there again and I'll drop a set off for you. Cheers, Al 1 Link to comment Share on other sites More sharing options...
Knucklehead Saloon Posted October 17, 2017 Author Share Posted October 17, 2017 Mate you're a bloody legend. I'll try autobarn first and go from there. Link to comment Share on other sites More sharing options...
Knucklehead Saloon Posted October 17, 2017 Author Share Posted October 17, 2017 Oh and yep, a part number would be excellent. Link to comment Share on other sites More sharing options...
djellum Posted October 19, 2017 Share Posted October 19, 2017 be cautious when buying the rears, on some models (mine) the axles dont come with the stub that goes through the bearing, only the cv joints between the stub and the rear end. they are often hard to get out so dont sledge it out thinking that the new one will have the stub and splines. I did this on one of mine, luckily the machine shop was able to save 3/4 of the threads so I could keep using it. Link to comment Share on other sites More sharing options...
Knucklehead Saloon Posted October 20, 2017 Author Share Posted October 20, 2017 Djellum: thanks for the heads up mate. Luckily I havnt removed mine yet, I make it a habit to only switch out parts after I've got the new ones in my hand. Too often in the past I've been caught out with wrong / incomplete / broken in transit parts turning up. As an aside, Over the years I've had brand new plugs that were cracked, new leads that were shot, new carbs with spoob in the float bowl, etc etc. Then spent hours and hours trying to track down faults while assuming the new bits were A-OK. These days I measure and inspect everything before it goes onto the bike/ car. Cheers. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now