2000 Subaru legacy wagon parts car

[3Pin]

I removed the engine and trans from this parts car and screwed up by leaving the drivers door window down.  With the wiring and battery mostly removed, I was wondering if I can just take a battery jump pack and provide power and ground to the wiring harness of the door and raise the window over winter.

 

Any ideas if this would work?

 

 

 

 

[montana tom]

Yes, that should work. 

[forester2002s]

Add a suitable fuse in series?

Just in case there's a short somewhere.

[GeneralDisorder]

Yes. Put a clamp on the fuel supply and return lines as the pump will power up when you turn the key on.

 

GD

[3Pin]

GD,

 

The fuse block and battery terminal is gone .  I was going directly to the door wiring that comes from the door and goes through the front opening and goes towards the drivers side fuse panel.  I was going to just disconnect the electric cable and feed  the blue red  which is up and down.

[lmdew]

Yep going direct should be fine.

[Fairtax4me]

Pull the door panel and just hook power straight to the wires on the window motor.

[3Pin]

Thanks.  That would be a lot easier.