rickyhils Posted August 15, 2018 Share Posted August 15, 2018 (edited) 1991 Loyale non-turbo won't crank. All other electric is ok. Happened after driver side timing belt broke. and loud backfire. Clutch safety switch ok. And have learned that EA82 is non interference design. SPFI. Have looked at Haynes book. all four fusible links next to battery are ok. Edited August 15, 2018 by rickyhils Adding missing info Link to comment Share on other sites More sharing options...
Dee2 Posted August 15, 2018 Share Posted August 15, 2018 45 minutes ago, rickyhils said: all four fusible links next to battery are ok Go back through the other items in power sequence -battery ok ? -fuses ok ? -starter ok ? Link to comment Share on other sites More sharing options...
rickyhils Posted August 15, 2018 Author Share Posted August 15, 2018 I found the problem. Loose fitting negative push on clip at starter motor was disconnected. Must have jumped off when engine backfired. With old cars there is always a long list of possible failure points that can show up. Link to comment Share on other sites More sharing options...
rickyhils Posted August 15, 2018 Author Share Posted August 15, 2018 Dee. Thanks for the reply. Weak push on connector negative at starter motor was the problem. Was most likely ready to fall off and the backfire shook it free. And, yes, the first thing I did was check those four fusible links near the battery. . I once had one of those get corroded and the whole car was dead-in-the-water. Thanks again. Link to comment Share on other sites More sharing options...
Len Dawg Posted August 15, 2018 Share Posted August 15, 2018 ====Weak push on connector negative at starter motor was the problem. Was most likely ready to fall off ==== exactly what I was going to say.. normal driving like any other day and then bam! Went back out to start and power everything but the starter I was lucky to have found it on a dark and freezing cold night! I was Ssstrrooking out! Link to comment Share on other sites More sharing options...
rickyhils Posted August 15, 2018 Author Share Posted August 15, 2018 Good that you located it when you did. Spending time to verify all connections to the engine is what is needed. With the vibration and the environmental elements (oil from engine flying all about over time). Thanks And if anyone looking for 1994 Loyale ECU box I just might have one that works. It came from Oregon. And do you know if California purposed ECU boxes have special coding inside them? Link to comment Share on other sites More sharing options...
DaveT Posted August 16, 2018 Share Posted August 16, 2018 California cars have an additional sensor, to verify egr operation. Not sure if the ECU is different, or has different programming. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now