Toadspit Posted September 18, 2018 Share Posted September 18, 2018 Or go ahead and pay the $100 core and sell off all the solenoids and then scrap the shell later? I really don't want to rush to remove the transmission to drive it 225 miles on Saturday. Share your logic and help me decide. Thanks Link to comment Share on other sites More sharing options...
montana tom Posted September 18, 2018 Share Posted September 18, 2018 Your post is kind of confusing toad. You found a tranny where? Is it local ? If so give them the old one and forget it. If it has to be shipped (like to foreign engines) Then keep it and pay the core. I doubt you'll be able to sell much from your old one certainly not $100 worth (imo) Link to comment Share on other sites More sharing options...
3Pin Posted September 18, 2018 Share Posted September 18, 2018 pay the core fee and keep your trans until after the swap. I always seem to end up grabbing something part wise off the donor. If you are all done, and want to take the core back after and it won't cost you too much in time or fuel, then take the core back after you are complete. That is what I usually do. Link to comment Share on other sites More sharing options...
lmdew Posted September 18, 2018 Share Posted September 18, 2018 1+ to 3 Pin Link to comment Share on other sites More sharing options...
montana tom Posted September 18, 2018 Share Posted September 18, 2018 Well of course you pay the core up front. Unless you do the whole job of removal first then go get your tranny. (who would do that) Get your tranny bring it home pull your old one out , steal whatever parts you want and bring them back a core. No shop expects a core until the job is done. Link to comment Share on other sites More sharing options...
Toadspit Posted September 19, 2018 Author Share Posted September 19, 2018 okay guys thanks for the input. First of all sorry about the post being confusing. I was on the clock and tried to post really fast. Apparently it was way too fast. I have taken my outback to my place of employment to start this swap. It is kind of nice being able to do this kind of work in a climate controlled garage which I don't have at home. So tomorrow after work I'll go to our grounds shop and start the removal process and I'll be taking the core to the yard that the used AT is coming from. I have no idea what a junkyard wants with the core but ooh well. I'm not sure what I should strip from the old AT but solenoids come to mind first. I'm pretty sure the clutch packs are gone in the old one since I had no transmission codes but I didn't have AWD. Thank you all for your input. I am greatful. Any other comments or suggestions are much appreciated Link to comment Share on other sites More sharing options...
3Pin Posted September 19, 2018 Share Posted September 19, 2018 Toadspit, take the core back after the swap unless it is a cash flow issue. Hard to say what parts you might want off the old one first. Once it is in their hands, it is impossible to grab what you might need. Link to comment Share on other sites More sharing options...
Toadspit Posted September 19, 2018 Author Share Posted September 19, 2018 I'm pondering that option right now. The only thing that makes that such a tough call is the transmission that fit my criteria is 225 or so miles away. Returning the core later makes that a 1000 trip. I wish I could have found one with decent milage much closer but subarus aren't quite as popular here as they are in other places Link to comment Share on other sites More sharing options...
montana tom Posted September 20, 2018 Share Posted September 20, 2018 Toad; Are you checking craigs list under auto parts? I know the NW has most of the Subarus but someone in Kansas should have a crashed one. 1 Link to comment Share on other sites More sharing options...
3Pin Posted September 20, 2018 Share Posted September 20, 2018 I would pay the core, grab any needed parts from your old one, put in the new one and recycle your own core at a local scrap yard and save the gas and windshield time. You can also ask them to waive the core. They do sometimes. 3 Link to comment Share on other sites More sharing options...
Toadspit Posted September 21, 2018 Author Share Posted September 21, 2018 I've checked Craigslist and had no luck which suprised me because I've seen them crashed on there before and I've even purchased a subaru legacy L on there that turned out to be an awesome deal. I finished pulling the transmission on mine yesterday after work. I ended up not pulling the engine a 3Rd time and it wasn't as difficult as I thought it would be. I've also gotten all of the external parts and the exhaust hanger off of it but I'm still nervous about needing something off of it after the exchange so I will call them today and ask about waiving the core charge. Thanks for the input guys Link to comment Share on other sites More sharing options...
Toadspit Posted September 22, 2018 Author Share Posted September 22, 2018 Road trip! I'm off to Missouri with a friend from work to get my transmission. We're about 2 hours away now and I can't wait to get it back and installed 1 Link to comment Share on other sites More sharing options...
3Pin Posted September 22, 2018 Share Posted September 22, 2018 Good luck! 1 Link to comment Share on other sites More sharing options...
el_freddo Posted September 22, 2018 Share Posted September 22, 2018 Was the core exchange waviered? Best of luck with the install and first drive! Cheers Bennie Link to comment Share on other sites More sharing options...
Toadspit Posted September 23, 2018 Author Share Posted September 23, 2018 /No they refused to waive the core but after leaving at 5am and getting back at 4pm I now have the used transmission bolted in but it's still at the shop and I'll finish hooking everything back up in the morning. Thankfully I have a good friend at work that jumped at the idea to make a road trip out of it with me because there is a pretty good chance my old van would not have made it. I made sure he didn't have to spend a dime on food or gas. I figured it was the least I could do. 1 Link to comment Share on other sites More sharing options...
Toadspit Posted September 23, 2018 Author Share Posted September 23, 2018 I actually thought about taking pictures and writing it up but because it was probably not the safest way to install it and as some of you know I don't always articulate my thoughts effectively and if my technique were to be exposed I would likely be banned from working on my stuff at our shop and possibly kicked off the safety committee lol Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now