steve56 Posted April 20, 2019 Share Posted April 20, 2019 Have 01 Legacy that I bought with blown engine. Just installed a Jdm ej20 and one cv axle. Pulled the front wheels. Brakes and rotors look good. Any ideas what would cause the steering wheel to shake when coming to a stop? Link to comment Share on other sites More sharing options...
jdkneppy Posted April 20, 2019 Share Posted April 20, 2019 (edited) When my Brat was doing the same thing, it was the rotors were warped. Had the rotors turned and problem solved. You could probably turn the rotors and check for run-out. Don't think a visual inspection will tell you. If not the rotors only other thing I can think of is tie rod ends really worn & sloppy. Good luck. Edited April 20, 2019 by jdkneppy Correction Link to comment Share on other sites More sharing options...
idosubaru Posted April 20, 2019 Share Posted April 20, 2019 Turning the offending rotor fixes this *every single time* Pay close attention to braking or try to feel it by rotating the wheels by hand- turn that one rotor and you’re done Or turn them both if you cant tell properly clean and grease the slide pins and make sure the pin bushings aren’t swollen-loose and impeding pin movement - and Subaru rotors will last 300,000 miles on average use daily drivers. Link to comment Share on other sites More sharing options...
el_freddo Posted April 20, 2019 Share Posted April 20, 2019 My bet: slide pins or a dead bearing. I often wonder how rotors warp. My L series did this from time to time but would often clear up after hard braking. Theory here being that the front disc hand brake would hold heat much longer than the rest of the disc - if hard braking occurred before hand brake on and engine shut down, the rotor would cool at different rates, and it could’ve left a small amount of brake pad baked on the rotor. I haven’t had rotors turned and it’s not an issue. If it’s persistent, it’s usually a jammed slide pin. And what do you always use with new or turned rotors? New brake pads. I believe this could mask the real issue - gummed up slide pins. Worn bearings will also allow the disc to move around that can create a rumbly braking sensation. I believe is this my current issue in my Brumby. Once I’ve finished the current house move this will be looked at - as will the slide pins as a matter of course. Cheers Bennie Link to comment Share on other sites More sharing options...
lmdew Posted April 20, 2019 Share Posted April 20, 2019 If you feel it in the bottom of the drivers seat first the rear disk could be the problem. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now