milty60 Posted May 31, 2019 Share Posted May 31, 2019 09 Forester 2.5x Manual tranny - hydraulic Clutch goes to the floor - my son can't shift into any gears - retired neighborhood mechanic checks it out - drops the tranny - discovers fork is broken and has previously been welded - replace clutch and fork puts tranny back on - clutch pedal all the way up - push to floor - can't shift into any gears - drops tranny again - has buddy comes over that is a Subaru mechanic - says its a Frankenstein - tranny is a Legacy - so he gets a Legacy clutch - using same fork - putting back together tomorrow morn - will see if it works tomorrow - is the Legacy tranny interchangeable between Forester- Legacy - Outback - etc - or the same manufactured tranny - and you have to know which clutch to get to match the tranny? One previous owner - had clutch replaced a few years ago - how does that beefy fork break? and who welds it? You guys think someone Frankenstein'ed this used car or are the trannys the same between Subaru's - hence the clutch screw up. Thanks, Bob Link to comment Share on other sites More sharing options...
FerGloyale Posted May 31, 2019 Share Posted May 31, 2019 Legacuy Forester Outback dossn't matter for clutch. it comes down to hydraulic clutch versus cable clutch. anything after like 99 is hydraulic so I doubt that is the issue. Forks break. Ussually replace with new. Welding is crap fix for emergency. Now if it has a Legacy trans, that would be way the wrong gear ratio for the Forester. I doubt you've had the wrong trans in all this time. My guess is improper bleeding of the clutch. Link to comment Share on other sites More sharing options...
1 Lucky Texan Posted May 31, 2019 Share Posted May 31, 2019 yeah, cracked/broken forks are a known thing. doesn't mean you couldn't also have a problem in the hydraulic system too. I've seen someone (Cusco, Perrin or ?????) that offers a HD fork - probably a good option for folks upgrading to hi-perf clutches. Link to comment Share on other sites More sharing options...
el_freddo Posted May 31, 2019 Share Posted May 31, 2019 Clutch/flywheel/forks - all interchangeable. I’ve got an EJ22 (4 bolt) bolted to an SG (8 bolt) cased L series dual range AWD locking centre diff gearbox with a Gen1 flywheel, pressure plate and cable clutch fork - in an L series Gearboxes, externally, the phase two boxes all look the same, but internally they have different gear ratios, diff ratio and speed sensor drive gear. Same goes for the phase1 gearboxes but externally they’re different to the phase two box. Internals are not interchangeable due to a change in the reverse gear setup/size. If a legacy box was put into the forester and the rear diff wasn’t swapped to the matching diff ratio you could have other issues with the gearbox. Keep us posted Cheers Bennie Link to comment Share on other sites More sharing options...
milty60 Posted June 4, 2019 Author Share Posted June 4, 2019 My son needs his manual tranny replaced - 09 Subaru Forester - having a hard time finding one at a bone yard - any suggestions? Does it make sense to rebuild it? Thanks, Milty Link to comment Share on other sites More sharing options...
1 Lucky Texan Posted June 4, 2019 Share Posted June 4, 2019 My 06 WRX wagon ate 2nd gear, local tuner shop rebuilt it, $2K probably would have looked for a used one at car-part.com except mine had very low miles. they claim 3rd gear is weak but sometimes 2nd goes. and second is cut onto a main shaft.... wish I'd had the money for a 6spd swap Link to comment Share on other sites More sharing options...
lmdew Posted June 6, 2019 Share Posted June 6, 2019 www.car-part.com is a good source. Link to comment Share on other sites More sharing options...
el_freddo Posted June 7, 2019 Share Posted June 7, 2019 I should add that NA clutches are interchangeable with each other. Turbo ones are not interchangeable. If you want the NA push clutch, you must also swap to the NA gearbox as the clutch pivot point is completely different. Cheers Bennie Link to comment Share on other sites More sharing options...
1997reduxe Posted June 7, 2019 Share Posted June 7, 2019 Also I was looking around for replacement trans for my 95 this year, luckily it turned out it was the synthetic gear oil I tried. Saved again. But I hadn’t noticed that on car-part, one of the sellers if you scrolled far enough was JDM suppliers. I never knew that JDM also sold transmissions. they are on Craigslist too. They may be more helpful in making sure they give you a compatible one. Some ads said they install also. https://hartford.craigslist.org/search/sss?query=subaru+forester+jdm&sort=rel Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now