gritle Posted September 14, 2020 Share Posted September 14, 2020 Hello, I drive a 2017 subaru OBW. recently the control for the passenger side window on the driver's door has stopped working. I hope this is something as simple as a fuse. Do people here have any other ideas or suggestions? Thank you, Craig Link to comment Share on other sites More sharing options...
gritle Posted September 14, 2020 Author Share Posted September 14, 2020 bump Link to comment Share on other sites More sharing options...
GeneralDisorder Posted September 14, 2020 Share Posted September 14, 2020 Too many possibilities. Either take it to a competent shop for a diagnostic or download the service manual and start testing. Obviously check your fuses. No one here is going to be able to do any of that for you. Too many control modules on a '17. GD Link to comment Share on other sites More sharing options...
ronemus Posted September 15, 2020 Share Posted September 15, 2020 The window control may need to relearn its limits; the procedure is fairly easy: run the window all the way up and continue to hold the switch up for a few seconds, the run it all the way down and hold - done. Sometimes the BIU gets "confused" and disconnecting the battery will reset it; you'll definitely need to reset the limits afterwards. Link to comment Share on other sites More sharing options...
moosens Posted September 15, 2020 Share Posted September 15, 2020 I’m curious how you set the limits. When I do motorized shades I do that either on the unit itself at the motor while toggling the step motor or remotely if that applies. So where would you be able to set limits from ? Thanks for the education. I’ll likely have a 2017 or one from that era .... oh maybe in a few years. For now I stick with the old school. Too much electronics these days. 1 Link to comment Share on other sites More sharing options...
gritle Posted September 23, 2020 Author Share Posted September 23, 2020 On 9/14/2020 at 8:39 PM, ronemus said: The window control may need to relearn its limits; the procedure is fairly easy: run the window all the way up and continue to hold the switch up for a few seconds, the run it all the way down and hold - done. Sometimes the BIU gets "confused" and disconnecting the battery will reset it; you'll definitely need to reset the limits afterwards. WOW! This suggestion is was did it! Thank you very much, greatly appreciated. I simply rolled the window all the way up, held the button in for a couple of extra seconds then rolled it all the way down and held it for a couple of seconds. It now works from both driver and passenger doors! like magic. 2 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now