Stevo F Posted August 12, 2023 Share Posted August 12, 2023 I have a low mileage (68K mile) 2000 Outback Limited that I recently acquired from my Dad. I recently replaced the alternator, and the following week, I noticed occasional vibration when turning the steering wheel at low speeds. The first thing I suspected was drive belt tension since I had just removed and reinstalled the belt when I replaced the alternator. Tightening the belt seemed to make it worse, and backing off the belt tension seemed to alleviate the vibration, but I still feel it occasionally. It also doesn't matter if the vehicle is moving or not and it while shake pretty well when moving the steering when parked in the garage. It will shake often but not all the time. I'm suspecting something with the power steering pump- could it need a good power steering fluid flush (power steering fluid level is good), or is the pump itself at fault? Link to comment Share on other sites More sharing options...
idosubaru Posted August 12, 2023 Share Posted August 12, 2023 9 hours ago, Stevo F said: I have a low mileage (68K mile) 2000 Outback Limited that I recently acquired from my Dad. I recently replaced the alternator, and the following week, I noticed occasional vibration when turning the steering wheel at low speeds. The first thing I suspected was drive belt tension since I had just removed and reinstalled the belt when I replaced the alternator. Tightening the belt seemed to make it worse, and backing off the belt tension seemed to alleviate the vibration, but I still feel it occasionally. It also doesn't matter if the vehicle is moving or not and it while shake pretty well when moving the steering when parked in the garage. It will shake often but not all the time. I'm suspecting something with the power steering pump- could it need a good power steering fluid flush (power steering fluid level is good), or is the pump itself at fault? Loosen and readjust the belt shroud to get pressure off the power steering hose. Link to comment Share on other sites More sharing options...
1 Lucky Texan Posted August 12, 2023 Share Posted August 12, 2023 possible air entrainment issue. May need new o-ring(s) on the suction hose adapter on top of the pump. very common issue. Link to comment Share on other sites More sharing options...
Stevo F Posted August 13, 2023 Author Share Posted August 13, 2023 11 hours ago, idosubaru said: Loosen and readjust the belt shroud to get pressure off the power steering hose. I checked but the belt shroud doesn’t come in contact with power steering hoses at any point Link to comment Share on other sites More sharing options...
el_freddo Posted August 13, 2023 Share Posted August 13, 2023 Check the hose between the remote reservoir and the pump. There could be cracks in it. This hose gets brittle over time so be gentle with it - give it a squeeze to see how flexible the hose is. Then try gently bending the hose, looking for cracks across the hose. If you’ve got cracks this is your issue with the PS system. Replace hose and see if the issue remains. Cheers Bennie Link to comment Share on other sites More sharing options...
sirtokesalot Posted August 31, 2023 Share Posted August 31, 2023 maby a strut top is seizing and making it bind when turning? Link to comment Share on other sites More sharing options...
nvu Posted September 1, 2023 Share Posted September 1, 2023 next time you catch it happening, open the reservoir and shine a light in, have someone steer the wheel with engine on. if you see bubbles it's a hose leak. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now