simpreza2 Posted July 20, 2004 Share Posted July 20, 2004 I have a car chip in my 97 OB and I have been keeping an eye on my coolant and everyonce in a while (2-3 timaes a day about 50 miles of driving) the coolant will rise to 204 and then go back to 185-ish. Any I dea whay this is happening? Should I get a colder Thermostat? Link to comment Share on other sites More sharing options...
rweddy Posted July 20, 2004 Share Posted July 20, 2004 simpreza2 said: I have a car chip in my 97 OB and I have been keeping an eye on my coolant and everyonce in a while (2-3 timaes a day about 50 miles of driving) the coolant will rise to 204 and then go back to 185-ish. Any I dea whay this is happening? Should I get a colder Thermostat? Is this a 2.5? Link to comment Share on other sites More sharing options...
simpreza2 Posted July 21, 2004 Author Share Posted July 21, 2004 rweddy said: Is this a 2.5? Yes...please dont tell me its a sign of my HG on their way out...the neddle doesnt move but the car chip says its changing temps. Link to comment Share on other sites More sharing options...
SevenSisters Posted July 21, 2004 Share Posted July 21, 2004 Somebody tell me what's wrong with 204F? Link to comment Share on other sites More sharing options...
tekfoc Posted July 21, 2004 Share Posted July 21, 2004 SevenSisters said: Somebody tell me what's wrong with 204F? just pick up the new subaru coolant conditioner thats being used on 2.5 motors that conditions the head gasket should solve your problem since your in the early stages of head gasket problems. 2.5 motors are very prone to head gasket problems after years of engine use. good luck Link to comment Share on other sites More sharing options...
rweddy Posted July 21, 2004 Share Posted July 21, 2004 tekfoc said: just pick up the new subaru coolant conditioner thats being used on 2.5 motors that conditions the head gasket should solve your problem since your in the early stages of head gasket problems. 2.5 motors are very prone to head gasket problems after years of engine use. good luck Actually the conditioner is for 00 and up 2.5, they leak externally and the "stop leak" from Subaru helps seal these up. 96-99 2.5 leak internally so the stop leak will not help you on the phase I motor. Hate to be the bearer of bad news but....... This is the early indicator of internal HG failure. Tempature spikes from air being introduced into the system from a leaking HG. Link to comment Share on other sites More sharing options...
Tiny Clark Posted July 21, 2004 Share Posted July 21, 2004 What are you doing when the temp goes up? Sitting still, going uphill? It's normal for a car temp to run a bit higher at these times. I would think if your head gaskets are leaking, you should be losing a bit of coolant. Link to comment Share on other sites More sharing options...
simpreza2 Posted July 21, 2004 Author Share Posted July 21, 2004 Tiny Clark said: What are you doing when the temp goes up? Sitting still, going uphill? It's normal for a car temp to run a bit higher at these times. I would think if your head gaskets are leaking, you should be losing a bit of coolant. I took a quick peek at the speed in relation to the temp and it doesnt match at all. I was idling for 5 min when it rose to 204 then when I started to drive again it went down. Ill look at more later but i got work now. Link to comment Share on other sites More sharing options...
rweddy Posted July 21, 2004 Share Posted July 21, 2004 Tiny Clark said: I would think if your head gaskets are leaking, you should be losing a bit of coolant. Actually with the phase I 2.5 they do not tent to leak that much coolant, but they allow air into the system causing the overheat. Link to comment Share on other sites More sharing options...
simpreza2 Posted July 21, 2004 Author Share Posted July 21, 2004 thanks guys. Ill just keep an eye on it and flush and fill the coolant when I get a chance (dont remember last time it was done) Link to comment Share on other sites More sharing options...
f15xxx Posted July 22, 2004 Share Posted July 22, 2004 try a new thermostat first before you go tearing the engine apart. sure sounds like a corroded thermo, they can grime up and stick if coolant not changed regularly. had the same problem in a 92 bronco that used green coolant. yup, it was a corroded mess. easy to change and also cheap. good luck. Link to comment Share on other sites More sharing options...
Setright Posted July 22, 2004 Share Posted July 22, 2004 Things might be perfectly all right. The coolant temperature is controlled mainly by the thermostat, and this a "proportional" control system. Therefore, it actually needs a little "error" for it to react. The temp will not be constant. I think the chip is a good idea, but don't let it make you panic. The dash temp gauge works on a delay, meaning that the average temp has to rise before the needle heads closer to the red. Same applies to the gas gauge, if it moved every time the gas slopped from side to side your needle would bounce around and be uselss. Link to comment Share on other sites More sharing options...
Tiny Clark Posted July 22, 2004 Share Posted July 22, 2004 I agree with Setright and shadow, you probably don't have a problem yet. As for allowing air into the cooling system, but not losing fluid, I don't fully comprehend. If there is a small space in the head gasket that blows air out of the combustion chamber and into the cooling passage, then a small amout of fluid should be sucked into the cylinder on the intake stroke. But, as always, reality can mesmerize theory... Link to comment Share on other sites More sharing options...
Sparrow Posted July 22, 2004 Share Posted July 22, 2004 It sounds very much like the problem I had...a leaking HG internally at the bottom edge of the #3 and #1 cylinders, on my '98 Legacy GT. Tiny Clark, the reason you don't see coolant in the engine oil and exhaust is because the leak is small. So, the hot gas can just squeeze through the crack, but the coolant, being a liquid not a gas doesn't make it back through the hole during the intake, before the next compression. If such a HG problem is suspect, look for an oily residue in the coolant reservoir, on the surface of the coolant and the inside of the tank. It won't be black, but it will look a bit dirty and kinda sticky/grimy to the touch. Also, look at the coolant level. If it is full in the reservoir, it may mean that the gases are displacing the coolant back into the tank. Your rad cap may have nothing wrong with it. Check for bubbles rising in your overflow tank, whilst the car is idling hot. Sure sign of head gasket problem. After I replaced mine myself in my landlords garage, the engine temp gauge doesn't move a hair once up to operating temp...and I often take it to redline. If you plan to tackle the job yourself, you may need to invest in about 30-40 beers to last you a long weekend! And a torque wrench. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now