Russ Hill Posted August 23, 2004 Share Posted August 23, 2004 Anybody know the correct/recommended helicoil and stud size for an EA82 exhaust stud replacement? Thanks, Link to comment Share on other sites More sharing options...
ezapar Posted August 23, 2004 Share Posted August 23, 2004 m10/1.25 Link to comment Share on other sites More sharing options...
GeneralDisorder Posted August 23, 2004 Share Posted August 23, 2004 Just an alternative that's cheaper than the heli-coil kits.... you can run a 7/16" x 20 tap into the existing hole with no drilling at all. Buy a tap, and a bottoming tap (or just cut the end off of a regular tap to make your own), and just run them in there. This avoids drilling, which you would have to do with the heli-coil kit, and it's much cheaper (about $10-$12 for the taps, versus $30 - $40 for the heli-coil kit). Going up a size makes it stonger too. And if you decide you don't like it later, you can always still do the heli-coil! You can then replace the old stud with either a stud or a bolt - use stainless if you can get it. And don't forget a flat washer and lock washer as well. GD Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now