kenfb1 Posted October 4, 2004 Share Posted October 4, 2004 Ok, I have a 98 outback limited with the heated seats. Switches are in console. Light is burned out in left switch for left seat. I removed console and can see no replaceable bulbs. It looks like the unit is sealed. Do you have to replace the whole switch to get lights to work??? If so, can someone give me a part number and where to order. Thanks In advance, Ken Link to comment Share on other sites More sharing options...
Cougar Posted October 4, 2004 Share Posted October 4, 2004 Someone else worked on these and was able to change the lights. I think the lights are accessed by removing the front cover but I'm not sure. Link to comment Share on other sites More sharing options...
macdonaldks Posted October 5, 2004 Share Posted October 5, 2004 I have a 97 Outback that had both lamps in the heater switchs burnt out along with the usual dash ones. I removed the switches from the console and then carefully pryed the switches apart using a small standard screwdriver. You have to be cautious so as not to drop the switch once its apart, as there are pieces inside that you might lose. Once apart, you will see two white rubber rings pressed down over two contact pins. These rubber rings hold the lamp filament wires in contact with the pins on the switch. Pry these rings up and you will be able to remove the small lamp. I replaced the lamps with ones I got at Radio Shack. Overall it is not a difficult job, just a delicate one. P.S. - work on one switch at a time so that you can use the other switch as reference if you need to. Link to comment Share on other sites More sharing options...
kenfb1 Posted October 5, 2004 Author Share Posted October 5, 2004 I have a 97 Outback that had both lamps in the heater switchs burnt out along with the usual dash ones. I removed the switches from the console and then carefully pryed the switches apart using a small standard screwdriver. You have to be cautious so as not to drop the switch once its apart, as there are pieces inside that you might lose. Once apart, you will see two white rubber rings pressed down over two contact pins. These rubber rings hold the lamp filament wires in contact with the pins on the switch. Pry these rings up and you will be able to remove the small lamp. I replaced the lamps with ones I got at Radio Shack. Overall it is not a difficult job, just a delicate one. P.S. - work on one switch at a time so that you can use the other switch as reference if you need to. Thanks,That was what I was looking for, someone who has done it. I had the switch almost out but thought I might break it prying it out. I will give it a shot, wish me luck. Thanks again, Ken Link to comment Share on other sites More sharing options...
Commuter Posted October 6, 2004 Share Posted October 6, 2004 Do a search for a topic titled "Climate Control Backlight" (I think). CincyBuckeye and I gave some very good instructions in that topic on this very issue. Commuter Link to comment Share on other sites More sharing options...
rigfennid Posted October 6, 2004 Share Posted October 6, 2004 I have a spare set if you don't get that to work for you. I'll verify that they work 100%. $10 + S&H is all I'd ask for the pair. Good luck with the bulb replacement! Brendan Link to comment Share on other sites More sharing options...
kenfb1 Posted October 6, 2004 Author Share Posted October 6, 2004 I have a spare set if you don't get that to work for you. I'll verify that they work 100%. $10 + S&H is all I'd ask for the pair. Good luck with the bulb replacement! Brendan I'm interested. E-mail me at: (kenfb1@echoes.net) Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now