Jump to content
Ultimate Subaru Message Board

What happened to my dash lights?


Recommended Posts

I went to drive the car tonight, and there are no dash lights. All the other lights work (like warning lights,interior, etc..) but there are no dash lights when the headlights are on. Is there a fuse somewhere? I checked the main fuse panel and couldn't find one specific to the dash, or any that were blown for that matter. Where do I start?

 

Thanks,

Matt

Link to comment
Share on other sites

What kind of car are we talking about?

On my 82 GL Hatch the dimmer knob would cause my dash to go off if I bumped it or moved it just a bit.

 

Try messing with the dash dimmer knob and see if you have dead spots on the switch? (or if the dash dimmer knob is adjusted all the way off :eek: )

 

Just a thought.. :confused:

Glenn

82 SubaruHummer

01 Forester

Link to comment
Share on other sites

Here is a strange thing to try ..but mine does this...just remembered too since its getting cold out..When I first start it I dont have any dash lights or stereo...but they come on once I wiggle the key up and down. Once the car is warmed up (or its warm outside) it goes away.I have a bad contact somewhere in the ignition switch ...and its partial to the colder weather.

 

Just a though.

Link to comment
Share on other sites

  • 6 years later...

I have a feeling my dimmer switch is dead, although when i try to

by pass it, a fuse blows I think. I'll have to try it again. (could have been

related to my now technically unplugged cig lighter)

 

Another thing is, the feedback/feel of the dimmer switch feels different,

it used to have resistance, clicks, and an upper and lower edge stopping point

and now it kind of freewheels no resistance.

 

Hmm i wonder if the same one is in an imprezza i have access to. I'll have to check that out.

Link to comment
Share on other sites

on my 89 GL wagon, the dimmer protion of the light switch was completely crapped out - as in the coils were burned thru - so no dash lights at all.

 

basically, i bypassed the dimmer portion & wired in some led's along the bottom of the dash panel - drilled small holes for the led housing to fit thru between the gauge faces and the clear outer cover - kind of ugly, but it worked. had always intended to "do it up" right, but never did get around to it. :rolleyes:

Link to comment
Share on other sites

My recommendation to confirm that it is the dimmer, go get a $5-$10 multi-meter from walmart, harbor freight, ect., and ohm it out. If the resistance is out of range, or infinite, it's dead. Make sure there is NO power to the switch when you do this, or you'll fry it. If it is, just go to the junkyard, and get a new one. If you'd rather something else, just go to autozone and pick up some $15 LED strips.

Link to comment
Share on other sites

  • 1 year later...

what i ended up doing was by passing the dimmer

 

and wiring in an LED, which i mounted by drilling a whole in the

bottom of the dashboard area, and put a small peice of tape over

the glass to keep ti from glaring at me..

 

Now i have a blue LED dash backlighs. it's kind of cool. I wanted red

but then it would have possible drowned out any red warning lights..

 

which remnds me, my CEL is on lol

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...