Tycho Posted January 4, 2005 Share Posted January 4, 2005 can anyone get me a scan of the clutch fork -> throwout bearing assembly. My TOB was completely "off" the fork when I pulled my engine and I don't have any technical manuals other than a sheet of torque specs. Link to comment Share on other sites More sharing options...
MilesFox Posted January 4, 2005 Share Posted January 4, 2005 the throwout bearing will fit onto the shaft, and the tongs on the side will be horizontal to the fork. there should be a pair of clips that hold it on, they look like paper clips somewhat, and one will point up and the other will point down. the clips fit into a small hole on either side of the fork and go around the tongs on the bearing Link to comment Share on other sites More sharing options...
torxxx Posted January 4, 2005 Share Posted January 4, 2005 yup miles is right. The TOB will pretty much only go on right one way. The clips wont snap down if its in backwards. The ears that the clips snap into should be on the tranny side. Link to comment Share on other sites More sharing options...
Tycho Posted January 4, 2005 Author Share Posted January 4, 2005 Hmm...these clips may or may not be on the fork... I'll take a peek when I get home. The TOB that was on there was just sitting there with the tongs totally free when I pulled the engine. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now