Where do these Rubber hoses go

[Myxalplyx]

 

Use the circles as a guide. I need to know where the two hoses on the bottom right-hand side of the blue circle plug into.

 

I also need to know where the two rubber hoses on the right side of the green circle (at 3:00 position) plug into.

 

 

Here's my situation below:

 

 

 

The car will almost be drivable after figuring this out. I need to fix an intake piece as well.

[rallyruss]

the green circle is the injector resistor pack. no lines shold go to that. there is a turbo managment valve behind it. that goes to the wase gate actuator I think.

 

the blue circle is the stupid sensor that turns on the turbo light. that line goes to a reducer then to the manifold on the right side.

 

the line with a curl on the end comes off the pressure side of the turbo I think.

 

for future line removal try painting or marking the lines color code style.

[85Sub4WD]

The red circle should be the cruise control actuator valve. One tube goes to the vacuum side of the intake, other goes to the actuator above the gas peddle.

[rallyruss]

doh.. I get it. the circles are just points of referance.

 

well my previous statment should still help you out.

[Myxalplyx]

doh.. I get it. the circles are just points of referance.

 

well my previous statment should still help you out.

Yes, they help. Thanks!

 

I 'stole' the circled pics from another thread in which I took this pic and someone modified it to help me...yet again.

 

And I know better to label/mark rubber hoses. I just went about tearing at stuff like a moron. Oops!

[WJM]

Yeah, I made that fer ya Kevin. :-p

 

Id take that silly turbo valve off, and just run a short line between the compressor housing and wastegate actuator, like the 85~86 turbo cars do.