newsooby Posted August 24, 2003 Share Posted August 24, 2003 I was removing my 12ft, 54lb kayak from the roof of my 99OBW when a gust of wind caught it and slammed the stern into the driver side passenger door! It left a shallow dent approximately 2 inches wide and 1 inch high, joining the other two shallow dents caused by shopping carts or the car doors of inconsiderate jerks. Anyway, the paint wasn't broken/cracked so I'm thinking of getting it fixed at a local detailing shop that does "paintless dent removal" that apparently uses some sort of suction device to pull the dent out with damaging the paint!? Has anyone had this done to their car? Does it work or is it a scam? A few weeks ago I noticed a service van for one such service that appears to be part of a franchise. Any feedback/input would be appreciated. Link to comment Share on other sites More sharing options...
brus brother Posted August 24, 2003 Share Posted August 24, 2003 It worked great for me with some fairly substantial dents. In my case it was a 2000GT with the newer glossy paints so go for it!! Link to comment Share on other sites More sharing options...
theotherskip Posted August 24, 2003 Share Posted August 24, 2003 you got off lucky! i dropped a 17.5' wood sea kayak off the roof of a civic i had, and it took the driver's side view mirror with it! there is a company called dentwizard who seems to have perfected it, and do it for most of the dealers in this area. they are also available to the public. you can find more info on their website at www.dentwizard.com . they have a variety of tools to remove dents from most places on a car. it is quite impressive to watch... Link to comment Share on other sites More sharing options...
dormat925 Posted August 24, 2003 Share Posted August 24, 2003 Dent wizard is the best. the guys who use suction can't do what dent wizard does they worked magic on two of my vehicles. Link to comment Share on other sites More sharing options...
brus brother Posted August 25, 2003 Share Posted August 25, 2003 The guys who did my car used a variety of metal prods and "pushed" or better put "romanced" the dents out. They were either the Dent Doctor or Dent Wizard. The result as I stated briefly in the earlier post was great. He went over the entire car and removed nearly all the mishaps. Link to comment Share on other sites More sharing options...
newsooby Posted August 25, 2003 Author Share Posted August 25, 2003 Thanks for the recommendation -- there are ton of them in Massachusetts (with all the crappy drivers around here business must be good!). What did it cost (you) to get the damage to your cars repaired? I'm looking for an approximate $$ range so I can get a rough idea of what it will cost me. Thanks. Link to comment Share on other sites More sharing options...
theotherskip Posted August 25, 2003 Share Posted August 25, 2003 just get an estimate. it is probably quite reasonable because it does not require a great deal of time. as mentioned before, they have a ton of specalized tools to gently push the dents out. when working on doors, they usually go in through the window (with it rolled down), and can reach most of the door. i've never seen them work on quarter panels, but i imagine they work through the wheel well. Link to comment Share on other sites More sharing options...
newsooby Posted August 25, 2003 Author Share Posted August 25, 2003 The Jaguar dealer near my office is a Dent Wizard "franchise?" Anyway, I'll call them for an appointment to get an estimate. It can't hurt and I'd love to get the exterior of my car "like new." I'll post the results -- maybe a photo, too. Thanks to all who responded. Link to comment Share on other sites More sharing options...
Ranger83 Posted August 25, 2003 Share Posted August 25, 2003 I used Dent Wizard in Peabody, they were excellent. Cost about $250 to remove the whole carload of dents, some small, some large. Link to comment Share on other sites More sharing options...
Subie Gal Posted August 25, 2003 Share Posted August 25, 2003 another happy Dent Wizards customer here!! they did an excellent job.... Jamie Link to comment Share on other sites More sharing options...
edrach Posted August 26, 2003 Share Posted August 26, 2003 Jamie, how do they do on fire damage?:madder: Link to comment Share on other sites More sharing options...
scoobynuts Posted August 26, 2003 Share Posted August 26, 2003 I've heard that using dry ice will work well too in taking out small (hailstone sized) dents. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now