Jump to content
Ultimate Subaru Message Board

half shaft replacment tools?


Recommended Posts

The cv boots split on the 96 Legacy, and I figure I just might as well replace the entire half shaft (front passenger). Though I was looking through the manual, and I am missing a couple tools. Where would be a good place to either buy or rent the axel remover and ball joint tool?

Link to comment
Share on other sites

Nothing needed for the axle. Just pull it out. The inner joint, you need a pin punch to drive out the pin. The balljoint does not need to come out completely. Just pull the bottom strut bolt, drop the torsion bar link and you can pry down the A-arm. That way you do not have to get a new alingnment.

 

Later, Larry

Link to comment
Share on other sites

Nothing needed for the axle. Just pull it out. The inner joint, you need a pin punch to drive out the pin. The balljoint does not need to come out completely. Just pull the bottom strut bolt, drop the torsion bar link and you can pry down the A-arm. That way you do not have to get a new alingnment.

 

Later, Larry

 

yup that's how i've done it before

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...