Jump to content
Ultimate Subaru Message Board

Chevy Rims


Recommended Posts

Well, that depends on which Subaru you are putting them on. For my Impreza, I have a set of 16 inch Chevy steel wheels for my snow tire, the only thing that needed to be done to them was enlargen the center hole a little. Heck, they even fit over my 4 pot front brakes.

Link to comment
Share on other sites

2 different ways.

 

either drill them out, using an old front hub as a pattern.

knock out 2 diagonal studs, and the spare hub will bolt up to the chevy wheel. then use the open stuf holes as a guide for drilling the new holes into the chevy wheel.

 

will look like this... (at the bottom of the page)

http://www.ultimatesubaru.org/80s/wheels2/wheels.html#modified

 

or have your hubs/drums drilled and converted to 6 lug as seen here...

http://www.subarubrat.com/6lugconv.htm

Link to comment
Share on other sites

I used basic measuring tools. As long as you measure "center to center" of the wholes you should be good to go.

 

Before you drill measure the distance between all the lugs and the distance from one lug to the next.

 

If they are all the same you should be good to go!

 

Center punch the holes before you drill to eliminate, drill bit wandering problems...

 

http://www.ultimatesubaru.org/photos/showphoto.php?photo=1386&sort=1&cat=500&page=2

 

Easy!!!

Glenn

82 SubaruHummer

01 Forester

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...