jray Posted July 28, 2005 Share Posted July 28, 2005 I am trying to program a new remote for my '99 outback. I have looked at several posts. Supposedly there is a little black reset button under the dash on the driver's side that one must hold down while hitting the 'lock' button on the new remote. Well, I have looked all over the place down there, and there is no button that I can find. I found a link on this message board to a site that even provided a diagram, but it didn't help. I would like to do this myself in order to avoid a trip to the nearest dealer 50 miles away. (Which is where I bought the remote, after being told someone was there who could program it 7:30 -5:30 M-F, only to get there at 4:30, and be told that 'all the techs left at 4:00.) If anyone out there can help me with this, I will very much appreciate it. Link to comment Share on other sites More sharing options...
Cougar Posted July 28, 2005 Share Posted July 28, 2005 There is no button on the '99. Here is some instuctions I copied that should help you. People have stated that you need to turn the key quickly from "off" to the "on" position within 15 seconds. I think the 10th time needs to be with the key left 'on' but it may be 'off'. Hopefully the horn will honk then. If that doesn't work then disconnect the battery briefly, reconnect it and try again. Instuctions: Unlock all doors. Cycle key quickly but carefully 'off' to 'on' appr 10 times until the car honks one time. Do not turn the key far enough to start the car, just to the 'on' position so the dashboard lights up. When the horn honks, open and close the driver's door, press any remote button and that's it. Program another remote? Quickly open and close the driver's door again and push a button on the 2nd remote. That's it. When you're done, remove the key and the horn should honk 3 times. You're all set. Sometime it takes more than 10 on-offs to set program mode. Open/close the door, lock/unlock etc, wait 10 minutes, then try again. Link to comment Share on other sites More sharing options...
jray Posted July 29, 2005 Author Share Posted July 29, 2005 Success! Thank you so much! Yeah, I kinda figured out there must not be a button after all the searching I did! Link to comment Share on other sites More sharing options...
Cougar Posted July 29, 2005 Share Posted July 29, 2005 Glad you got it. Did the horn honk when you turned the key to the on position of the off position on the 10th turn? Link to comment Share on other sites More sharing options...
c_W_j Posted July 9, 2010 Share Posted July 9, 2010 not working at all for me.... Link to comment Share on other sites More sharing options...
Cougar Posted July 10, 2010 Share Posted July 10, 2010 If the process doesn't work then start the engine and turn it off. Then try the process again. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now