carfreak85 Posted November 13, 2005 Share Posted November 13, 2005 I'm trying to get the hubs off my wagon, and I have everything off except the disc and hub. They are still on the axle. The cone washer is stillin there and I can't seem to get it off. I don't want to pry on it too hard since I don't have too many sitting around. I need this car to be done tomorrow night so any help you can give would be great. Link to comment Share on other sites More sharing options...
Snowman Posted November 13, 2005 Share Posted November 13, 2005 Try various punches and chisesels with a BFH. It will come off with a little BFH lovin'. Link to comment Share on other sites More sharing options...
TheSubaruJunkie Posted November 13, 2005 Share Posted November 13, 2005 This method has never failed me, or shown signs of damage to any components.... take the castle nut completly off, and remove the flat washer. Take the castle nut, and begin to thread it onto the CV shaft backwards (with the split portion of the threads 1st). It maybe difficult if you dont get all the threads lined up, but you want to thread it almost all the way on. Leave a small portion of the castle nut to overlap the CV shaft. You want to give the CV a good whack with a hammer. The nut should take the brute force and keep the threads on the CV safe. One solid whack is all it needs to break it loose, the cone washer should pop out of place and your hub and rotor will fall right off. A good soaking in WD40 or any penetrant should help as well if its fused in place. Good Luck, -Brian Link to comment Share on other sites More sharing options...
Subarian Posted November 13, 2005 Share Posted November 13, 2005 One or two raps on the edge of the cone washer with a chisel and a hammer ought to do it. Link to comment Share on other sites More sharing options...
calebz Posted November 13, 2005 Share Posted November 13, 2005 Couple of good smacks on the end of the axle with a rubber mallet works every time for me. Link to comment Share on other sites More sharing options...
edrach Posted November 13, 2005 Share Posted November 13, 2005 All of the above work; as a last resort, take out the four bolts holding the hub and remove it; knock the cone washer out of the hub from the inside. Link to comment Share on other sites More sharing options...
carfreak85 Posted November 13, 2005 Author Share Posted November 13, 2005 Thanks a lot for the advice guys! Thats why I love this board so much! I ended up using a BFH and a block of wood to beat on the end of the axle. Worked like a charm! Link to comment Share on other sites More sharing options...
NoahDL88 Posted November 13, 2005 Share Posted November 13, 2005 Dirty little secret, that roll pin punch is the right size to slip into the hole at the end of the axle, hit the punch with the hammer and you'll never have to worry about marring threads again. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now