subiemech85 Posted November 22, 2005 Share Posted November 22, 2005 what's the trick to removing the rotor when it's stuck on the shaft? I did remove the screw! '89 RX Link to comment Share on other sites More sharing options...
Subarian Posted November 22, 2005 Share Posted November 22, 2005 If you're talking about getting the hub off the axle shaft, you have a couple of options. one is to use the castle nut. Turn it around so the flat side is out and thread it on the shaft until the shaft is just below the outer edge of the nut. This will protect the threads of the shaft while you smack it with your biggest hammer. Another way is to use a drift punch in the depression in the middle of the shaft. Either way, you just need to protect the threaded end of the shaft while you convince it to move. Link to comment Share on other sites More sharing options...
NoahDL88 Posted November 23, 2005 Share Posted November 23, 2005 If you are sure you removed the screw, then just pull harder, sometimes they get stuck on. Link to comment Share on other sites More sharing options...
jeffast Posted November 23, 2005 Share Posted November 23, 2005 hit it with a hammer on the top then the bottom then repeat this trick usually works for me unless you have a ford escort and the shaft has enlarged and the rotor has become one with the axel never mind long story Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now