theflystyle Posted January 21, 2006 Share Posted January 21, 2006 hello members.. i ordered some stainless steel goodridge brake lines and noticed something a little odd about the lines... each line (4 in total) is a little bit different in length and has a nut that seems to be at a different location on each line. here is a pic of the items in question, the circled parts are at different lenghts on each line, as well as each line is a little different in length. im sure its not a big deal but i just wanted some xpert advice -ali Link to comment Share on other sites More sharing options...
Legacy777 Posted January 21, 2006 Share Posted January 21, 2006 Are they specifically for a legacy? Link to comment Share on other sites More sharing options...
theflystyle Posted January 21, 2006 Author Share Posted January 21, 2006 thats what it says on the goodridge box, as well as what i ordered... any ideas?? the place i got them from says that since goodridge doesnt have these parts just ready to ship, that they instead just build each order when its recieved. if that matters at all?? Link to comment Share on other sites More sharing options...
Tiny Clark Posted January 21, 2006 Share Posted January 21, 2006 Don't those large threaded assemblies go thru the strut housing? I believe they are all different sizes due to the distances from each strut housing to the attach point on the calipers being different. Link to comment Share on other sites More sharing options...
Hocrest Posted January 21, 2006 Share Posted January 21, 2006 Ideally there should be two that match up for the front and two that match up for the back... As long as the center lug is in a range to fit into the strut mount and allow full range of steering, they should be OK. Link to comment Share on other sites More sharing options...
theflystyle Posted January 21, 2006 Author Share Posted January 21, 2006 they do attach to the strut, but my thinking was that it should have at least matching pairs as well.. after i install ill post the news Link to comment Share on other sites More sharing options...
1 Lucky Texan Posted January 21, 2006 Share Posted January 21, 2006 maybe mark the old ones as you remove them, then find the closest 'twin' from the SS lines to reinstall? Interesting, please let us know how it works out OK? Link to comment Share on other sites More sharing options...
porcupine73 Posted March 7, 2007 Share Posted March 7, 2007 Hi theflystyle, did you figure out how these brake lines install? I'm asking because I was thinking of getting these lines for my '00obw and '96 legacy. My guess on your issue is that you said the place made them themselves, so they probably didn't cut the lengths exactly the same. Link to comment Share on other sites More sharing options...
theflystyle Posted March 8, 2007 Author Share Posted March 8, 2007 they installed fine, and i just had to secure them (zip ties) so they wouldnt move around to much... but they were well worth it, while your down there think about checking your brakes, like a rebuild with gaskets, etc... Link to comment Share on other sites More sharing options...
porcupine73 Posted March 8, 2007 Share Posted March 8, 2007 Thanks for the info theflystyle. Yes I had a siezed caliper guide pin on the rear and the wheel got hoootttt so I'm checking over all the brakes now. That's what made me think about upgrading flex lines. For the '00obw I ordered stoptech front and rear lines since I was ordering rear rotors anyway. For the '96 I might try the goodridge when I do the rear drum to disc changeover. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now