Jump to content
Ultimate Subaru Message Board

defroster problems?


Recommended Posts

The cable probably came apart, the wire part still will be in the correct place, but the end of the cable case breaks off at the clamp. On mine, I pulled the heater control panel, pulled the thing into defrost position, and put it all back together. It's ok until you move it off the defrost position.

Link to comment
Share on other sites

a vacuum line under the hood probably came undone. There should be a line from the intake manifold to the clear-ish looking canister on the passenger side rear of the engine bay. There should be another line going from the canister to the driver side firewall.

 

If this gets unhooked, you won't have any control over the vent settings.

 

I had a case once when under heavy load, the vents would shift from defrost to bi-lev. Replaced that vacuum cannister and fixed the problem.

Link to comment
Share on other sites

a vacuum line under the hood probably came undone. There should be a line from the intake manifold to the clear-ish looking canister on the passenger side rear of the engine bay. There should be another line going from the canister to the driver side firewall.

 

If this gets unhooked, you won't have any control over the vent settings.

 

I had a case once when under heavy load, the vents would shift from defrost to bi-lev. Replaced that vacuum cannister and fixed the problem.

thanks i will looking it tomorrow in the day light. i will let ya know if that is the problem.

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...