Jump to content
Ultimate Subaru Message Board

Recommended Posts

ok, i did a search and couldn't find what i was looking for.

 

right now i've got NGK plugs with stock wires.

 

my #4 plug is burning oil but that's beside the point.

 

is it actually worth upgrading wires for power?

 

recommendations?

 

i would say yes but thats just me. The rubber breaks down with time and can cause running problems and a weak spark. Replace with subaru wires.

 

 

nipper

Link to comment
Share on other sites

dealer wires are the way to go.

 

magnecor wires are excellent too. they've done multiple designs to deal with the quirkiness of the spark plug chamber.

 

off the shelf wires suck in the EJ series motors because they aren't designed with tight enough tolerances or materials up to task. i've used them before and they will short out immediately, i can't believe they continue to even supply them. they'll short out around the spark plug holes, apparently the deep holes make seating and fitment an issue. any compromise in the boot leaves a short cut to the side wall of the chamber. the spark will short out the side of the boot to the chamber, seen them, burns right through them. this is partially speculation, but i have seen it and they usually blow through the plug boot for sure.

 

magnecor went through a growing phase with these wires and that's why they only carry one size/style wire for the EJ22. i have a set on my EJ22. i've bought numerous sets of wires from magnecor for jeeps, fords, older generation subaru's so i gave them a chance. i have had excellent results with these other vehicles. they are awesome wires and will last the life of the car. i've run one set for 200,000 miles. they have been fine on my impreza.

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...