Jump to content
Ultimate Subaru Message Board

The axle is supposed to look like this.. right?


Andyjo
 Share

Recommended Posts

Well.. as a result of my romping around offroad... (ie: offroad section).

So the story... after playing in the dirt/mud/rocks the roo' got a funny shimmy in the front the... you know, no big deal, i play it off as just an out of balance tire... a few days go by lots of driving to work & back... i head north to upstate vt (~150 mile drive) and about 8 miles from my destination (st albans vt) i hear a 'pop' and the whole car shakes like crazy when i push the gas... so as any person who loves their car would do, i kept driving the 8 miles, shaking all the bolts out of the car :rolleyes:

get there... stop... think a bit, and look under the car, and yup, just what i had though... inner axle joint didn't like life anymore. So no big deal... run over to advanced auto, get a new one (GCK baby :headbang: ) and meet up with the girl, and we head to the camp ground... now.. i forgot to mention the part where i didn't bring any of my tools... :banghead:

So i think.. eh.. no big deal.. make some phone calls... (good to have friends everywhere)... the next day (saturday) in the rain we have an adventure swaping out my axle in the rain.. needless to say, the 3lb mini-sledge is most likely on of my favorite tools now :rolleyes: but wait... we don't have a good jack.. (i hate scissor jacks..) so i find a stump next to a hole... back up (read romp) onto that setup.. lift the front drivers side up.. continue to work on her.

So yeah, everyone here hates reading, so here are some pics of the axle (none of the setup :-\ )

axle2.jpg

 

3lbs sledge.. meet the end of half shaft... it really didn't want to come out of the bearing.. so we showed it who was boss ;)

axle1.jpg

 

So in this picture... the only thing really keeping the joint together is the remainer of the boot on the back side there.... later on we pulled the joint apart... just because we could :eek:

 

So, if you were at lake carmi campground this past weekend.. i'm sorry for all of the metal-on-metal noise coming from us beating the snot out of my axle... So once we got the new axle in... found out that when we were beating the axle stub... someone nicked on of the studs... so one of the lug nuts wouldn't go on.. no big deal.. just have to fix that someday :rolleyes:

So all in all... if you're going to bust an axle like that... find somewhere where you have good friends with tools... and 3/4" drive sets :D

So...

Most valuable tool of the trip: 3lbs mini-sledge

Most sucky thing of trip: pouring rain & scratched windshield from crappy wiper blades :-\

Link to comment
Share on other sites

Sounds like heaps of fun was had.

 

About 5 weeks after I got my first subie I pulled the axle out to change the inner boot. I put the race casing back in the wrong way round. Went around a really sharp left and put my foot down and it popped out. And the joint wouldn't go back in. Had to fix that at a mates place cos I was 2 hours from home.

Isn't it just fun working on cars with limited tools and in the wet and cold? My bro has a garage with a pit now.. Makes life so much nicer :)

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...