fnlyfnd Posted November 26, 2006 Share Posted November 26, 2006 So I went driving on a not road surface today. It got pretty crazy in some parts, narrow, rutted, deeper ruts, high centering but going to fast to be stoped, turn after turn, mud, etc..... Well I came to a spot where the water was prolly up to the top of the bumper so I floored it. I was close enough to not get a whole bunch of momentum, actually I prolly didnt even gain any momentum by the time I dove in. The car died, full gas and it just stopped. No revs, no spinning, just a sudden drop in rpm. I thought it stalled, but it didn't. After a few seconds I threw it back into first and proceded to get out. So what do you guys think?? Oh, another thing...when I got back to the road I floored it, it was going good then it was a sudden jerk - loss of power....so what gives?? This only happens when wet, I noticed this after once before when I went through a deep puddle (on road). Link to comment Share on other sites More sharing options...
NoahDL88 Posted November 26, 2006 Share Posted November 26, 2006 Check your air filter, if its wet, your engine is probably too. ( the inside, not the ok side ) If it still runs, do a compression check. if there not even you may have bent a rod. Link to comment Share on other sites More sharing options...
GeneralDisorder Posted November 26, 2006 Share Posted November 26, 2006 Ignition stuffs may have gotten wet. Check all your plugs and wires, etc. The EJ's tend to bend rods or break pistons when they get sunk in water like that. Get yourself a snorkel if you plan to do this a lot. And change your oil - water contamination is pretty sinister on the lube system. GD Link to comment Share on other sites More sharing options...
ryry46d9 Posted November 26, 2006 Share Posted November 26, 2006 it does it all the time when it rains? my moms boyfriend was working on a customers car for almost 2 weeks (even drove it home couple of nights trying to find out what was going on) every time they came to his shop it was fine and showed no codes turned out when it rained the map senser would freak out telling the computer lies dont rember what caused it but i think it was a tare in the freash air line probley not your case but i thought i would share this crazy case ryry zzz Link to comment Share on other sites More sharing options...
Numbchux Posted November 26, 2006 Share Posted November 26, 2006 for future reference, don't floor it when going through water. it just splashes more water around, and causes the engine to suck more air (and potentially water). smooth, slow, and steady is the way to go. I'd bet on wet electrical connections. these motors are completely electronically controlled....if it gets a goofy signal from anything, it won't run quite right. Link to comment Share on other sites More sharing options...
NoahDL88 Posted November 26, 2006 Share Posted November 26, 2006 Brings up a good point, check all your electrical connections to make sure that they are clean and dry. Link to comment Share on other sites More sharing options...
fnlyfnd Posted November 26, 2006 Author Share Posted November 26, 2006 not in the rain, just the flooded road. I do have a snorkel Yes the obw in my pic Link to comment Share on other sites More sharing options...
beataru Posted November 27, 2006 Share Posted November 27, 2006 Did the dash gauges and lights die also??? Link to comment Share on other sites More sharing options...
fnlyfnd Posted November 27, 2006 Author Share Posted November 27, 2006 gauges were working, lights were off Link to comment Share on other sites More sharing options...
fnlyfnd Posted November 27, 2006 Author Share Posted November 27, 2006 . Link to comment Share on other sites More sharing options...
LosDiosDeVerde86 Posted November 27, 2006 Share Posted November 27, 2006 Oh, another thing...when I got back to the road I floored it, it was going good then it was a sudden jerk - loss of power....so what gives?? This only happens when wet, I noticed this after once before when I went through a deep puddle (on road). ok.. this is EXACTLY what happens. If you spray water on your MAF sensor the engine shuts down. if you spray less water on it, if gets bogged down with a loss of power. there you go. your MAF got wet. Link to comment Share on other sites More sharing options...
fnlyfnd Posted November 27, 2006 Author Share Posted November 27, 2006 sweet thanks for the direct answer. Sealing up the little area where the water can still pass by the snorkel very soon. So I changed the diff and motor oil and they seem to be fine. Do you guys think I am in trouble?? Link to comment Share on other sites More sharing options...
LosDiosDeVerde86 Posted November 27, 2006 Share Posted November 27, 2006 sweet thanks for the direct answer. Sealing up the little area where the water can still pass by the snorkel very soon. So I changed the diff and motor oil and they seem to be fine. Do you guys think I am in trouble?? no, just be careful not to let ANY opening on your intake get wet. seal it up nice and tight and you'll be good to go. Link to comment Share on other sites More sharing options...
LosDiosDeVerde86 Posted November 27, 2006 Share Posted November 27, 2006 (Okay, I admit it - I use it because I like the smell of it...) ooo...yeah....me too Link to comment Share on other sites More sharing options...
zukiru Posted November 28, 2006 Share Posted November 28, 2006 that's a little scary, lol!! Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now