toadleyb Posted November 30, 2006 Share Posted November 30, 2006 I have been searching and reading for the last couple of hours and have a couple of questions. I have an 87 DL Wagon. I was under it yesterday doing some exhaust work and noticed the outer boot on the front driver's side is completely split in half. I did some searching about replacing the boot and it seems the general opinion is that it is easier to replace the axle than the boot. I read the write up by Edrach. When people refer to the "axle" or "half shaft" what exactly is this? Is it the entire assembly from the DOJ out to the CV joint? The outer boot from what I have read can be replaced by taking the whole shaft out and then removing the DOJ and the inner boot, correct? Where can I buy replacement boots? I am assuming directly from a Subaru dealer. From what I have read aftermarket boots are not as good quality as the OEM boots? Thanks for the help Link to comment Share on other sites More sharing options...
Syonyk Posted November 30, 2006 Share Posted November 30, 2006 Axle/half shaft refers to the entire assembly - all three segments. And if the boot is split, you're probably going to be better off replacing the entire halfshaft. If it's been split for a while, dirt/grime often gets in & will chew up the joints. Also, there are companies that make split boots that go on without needing to pull the axle - they wrap around it and secure together somehow. That might be worth trying as well if the joint isn't making any noise. If you're getting clacking during corners, replace the axle, but if not you'd probably be fine with a replacement boot & repacking the joint with clean grease. -=Russ=- Link to comment Share on other sites More sharing options...
GeneralDisorder Posted November 30, 2006 Share Posted November 30, 2006 Don't *have* to take the shaft out (or even the wheel off). Inner control arm bolt, sway bar link, the DOJ roll pin, and the inner joint pulls off the tranny. Then dissasemble the inner joint while it's on the car, and slide two new boots on. Clean as much dirty grease out as you can, and fill the new boots and joints with moly. Use some SS hose clamps to tighten the new boots. GD Link to comment Share on other sites More sharing options...
toadleyb Posted November 30, 2006 Author Share Posted November 30, 2006 Thanks for the answers. Guess I will go on a mission for new boots tomorrow and tackle it. Link to comment Share on other sites More sharing options...
89thorn Posted December 1, 2006 Share Posted December 1, 2006 Just for my curiosity, i have heard that the split boots often leak. I have never tried them if you do. Say how they work maybe. Link to comment Share on other sites More sharing options...
GeneralDisorder Posted December 1, 2006 Share Posted December 1, 2006 89thorn said: Just for my curiosity, i have heard that the split boots often leak. I have never tried them if you do. Say how they work maybe. They are junk - only slightly better than saran wrap, or duct tape. GD Link to comment Share on other sites More sharing options...
toadleyb Posted December 1, 2006 Author Share Posted December 1, 2006 I have no intention of using a split boot. Link to comment Share on other sites More sharing options...
toadleyb Posted December 1, 2006 Author Share Posted December 1, 2006 Okay I just called cvaxles to see about getting a new shaft for my car. Anyone out there know if an 87 DL Wagon would be the 23 spline or 25 spline. It is either part #cv-6505 or 6503 but they were not sure. Link to comment Share on other sites More sharing options...
GeneralDisorder Posted December 1, 2006 Share Posted December 1, 2006 GCK axles - Brand new from Autozone are about $100 no core. Beleive me, they are the best. www.gck.com 23 spline is what you need. GD Link to comment Share on other sites More sharing options...
toadleyb Posted December 1, 2006 Author Share Posted December 1, 2006 Thanks for the help. I ordered one from cvaxles.com it seemed to be the popular spot here from all the reading I did. It was only 55 plus shipping for a reconditioned. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now