Vortex XT6 hub conversion to RX Turbo ?

[discopotato03]

Hi all , not many XT6's in Australia so I'm wondering if anyone has pics of the 4 and 5 stud rear hubs . I need to know if its possible to drill the 5x100mm pcd stud holes in the 4 stud rear hubs if need be .

 

Thanks Adrian .

[Gloyale]

Hi all , not many XT6's in Australia so I'm wondering if anyone has pics of the 4 and 5 stud rear hubs . I need to know if its possible to drill the 5x100mm pcd stud holes in the 4 stud rear hubs if need be .

 

Thanks Adrian .

 

Loyale2.7 drilled his to some smaller 4 bolt pattern. 4x110 maybe? Something smaller so I think it would be possible. But with 5 you'll end up with one or two of the holes being really close.

[kiwi subbie]

do ya know about the place some were in ozzy that convert legacy hubs to fit ea82 stuff? i know its pricey tho

[discopotato03]

I drew up a "clocking" diagram and noted 100 and 140mm PCD . Assuming the stud holes are 12mm the closest will be 20mm apart (centres) and the holes themselves 8mm . This should not be a problem for a steel hub I think .

 

With the 4 stud rear disk type does the disk slide over the hub or bolt behind it ?

 

Cheers A .

[Gloyale]

I drew up a "clocking" diagram and noted 100 and 140mm PCD . Assuming the stud holes are 12mm the closest will be 20mm apart (centres) and the holes themselves 8mm . This should not be a problem for a steel hub I think .

 

With the 4 stud rear disk type does the disk slide over the hub or bolt behind it ?

 

Cheers A .

 

It bolts behind like the front hubs.