starsea Posted June 16, 2007 Share Posted June 16, 2007 Not having a ST 499977000 tool or a face spanner wrench Doug Penland came up with this method of removal of the crankshaft pulley. (the photo was taken while we were putting it back on. to remove, the bar would be behind the upper extension and in front of the bottom one) the tools the placement Link to comment Share on other sites More sharing options...
msmithmmx Posted June 17, 2007 Share Posted June 17, 2007 Or you could remove the flywheel access hole and stick a wrench in there to lock it up. You Decide:headbang: Link to comment Share on other sites More sharing options...
edrach Posted June 17, 2007 Share Posted June 17, 2007 Removal is easy; but your suggestion would help greatly in the replacement. Easiest way to remove: 1/ Dis-able ignition by unplugging most sensible item 2/ Put 22mm socket and breaker bar of suitible length and rotate by hand clockwise until the bar hits the fender well on the driver's side. 3/ Turn ignition to use starter motor to rotate engine momentarily. Just a short jolt is all that's needed. Link to comment Share on other sites More sharing options...
Skip Posted June 17, 2007 Share Posted June 17, 2007 I have a question and my question is this. That is a #2 pencil I saw no mention of drilling the holes out? Note: This damper is from an EJ22T The one from my EJ25 has larger holes but the are in the rubber cushion only. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now