nathan_d Posted June 18, 2007 Share Posted June 18, 2007 so i had everything on my brat for my lift and am putting the lower ball joint back in and the strut on the driver side of my brat will not compress... any ideas? do i just need to bite the bullet and buy a set of new ones? or did it spin and lock or something? Link to comment Share on other sites More sharing options...
86BRATMAN Posted June 18, 2007 Share Posted June 18, 2007 You are probably going to have to use more than just your strength to get it to compress enough to go in. Like a floor jack and a piece of wood on the hub. Link to comment Share on other sites More sharing options...
nathan_d Posted June 18, 2007 Author Share Posted June 18, 2007 I was using a floor jack and it was just lifting the whole body off of the jack stands... Link to comment Share on other sites More sharing options...
86BRATMAN Posted June 18, 2007 Share Posted June 18, 2007 How far from hitting the hole are you? Link to comment Share on other sites More sharing options...
nathan_d Posted June 18, 2007 Author Share Posted June 18, 2007 quite a ways, what worries me though is my strut on this side is not compressing at all where as the one on the other side actually compressed? Link to comment Share on other sites More sharing options...
86BRATMAN Posted June 18, 2007 Share Posted June 18, 2007 That could be one of two things. The other one could be bad, or that one could be stuck Link to comment Share on other sites More sharing options...
nathan_d Posted June 18, 2007 Author Share Posted June 18, 2007 if it is lifting the body that should be enough weight to compress the strut right? is there any other way to pull the ball joint in? Link to comment Share on other sites More sharing options...
86BRATMAN Posted June 18, 2007 Share Posted June 18, 2007 I would assume it would, I've changed ball joints by the jack method and it compresses the spring. When I changed out the struts on them. I'd leave the ball joint in, remove the strut from the knuckle, and disconnect the sway bar on that side to let it drop the lca more, bolt the strut to the tower and work it into the hole on the knuckle. Link to comment Share on other sites More sharing options...
mykingcrab Posted June 20, 2007 Share Posted June 20, 2007 Link to comment Share on other sites More sharing options...
mykingcrab Posted June 20, 2007 Share Posted June 20, 2007 http://www.ultimatesubaru.org/forum/showthread.php?t=49980 Link to comment Share on other sites More sharing options...
86BRATMAN Posted June 20, 2007 Share Posted June 20, 2007 ^^^ Good point... Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now