Nate007 Posted June 26, 2007 Share Posted June 26, 2007 anybody find it unusually difficult to split the motor from the tranny? Link to comment Share on other sites More sharing options...
rllywgn Posted June 26, 2007 Share Posted June 26, 2007 when theres bolts still in place yes.. although sometimes nudging does help if all said fasteners have been removed Link to comment Share on other sites More sharing options...
MilesFox Posted June 26, 2007 Share Posted June 26, 2007 place a jack at the differential and raise it up until the motor mounts rise out of the holes on the crossmenber. lf the motor is stuck against the bellhousing(it would be if the motor was never pulled berofe) you can start a small screwdriver with a hammer between the motor and the tranny working from the sides and down to wherew the dowels would be. once you get enough gap you can go with a larger screwdriver and then a crowbar of some sort... Link to comment Share on other sites More sharing options...
Nate007 Posted June 26, 2007 Author Share Posted June 26, 2007 ya, it just took some wiggling and it popped right out. Link to comment Share on other sites More sharing options...
joostvdw Posted June 26, 2007 Share Posted June 26, 2007 when you install the engine, be sure to clean all surfaces and put some anti-seize on the bolts/dowelpins, if it's hard to pull out, it's going to give you hell putting it back in :-p (if you don't clean/grease it) Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now