banshee400 Posted August 4, 2007 Share Posted August 4, 2007 I'm finishing up the swap on my 99 Forester and noticed that the A/C compressor mount is one of a few differences between the 99 and the 2003. When we took the mount off to swap it over one of the bolts appears to have some sort of a sealant on it. It's only on this one bolt. Does anyone know what if any sealant I would need to apply to the bolt? Thanks! Oh, if anyone is intersted a few of the other diffences between the 99 an the 2003 2.5L are the intake manifold, PCV connection on the block, and the knock sensor. I'll post the complete list when I'm finished. Link to comment Share on other sites More sharing options...
eryque Posted August 4, 2007 Share Posted August 4, 2007 Sealant on the bolt itself? Are you sure it's not just blue locktite to keep it from loosening? Link to comment Share on other sites More sharing options...
banshee400 Posted August 4, 2007 Author Share Posted August 4, 2007 Sealant on the bolt itself? Are you sure it's not just blue locktite to keep it from loosening? This is a yellow or orange colored material. Link to comment Share on other sites More sharing options...
banshee400 Posted August 4, 2007 Author Share Posted August 4, 2007 There's also a similar red sealant used on the right front bolt that holds the alternator mount. Link to comment Share on other sites More sharing options...
ron917 Posted August 4, 2007 Share Posted August 4, 2007 That would be a thread locker of some kind. I noticed it on some of the accesory mount bolts when I did my engine swap. While it was reddish in color, it wasn't the familiar red Loctite from a tube, because they came right out. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now