Jump to content
Ultimate Subaru Message Board

anyone have dual exhaust on their brat?


Recommended Posts

Used the stock first 8 inches of Y pipe where it goes straight, then custom bent to reach under the tranny mount then each side veers past the frame rail where it meets the purplehornie sidepipe. 3inch pipe exits at an angle.

 

You can see the pipe exit here:

 

or1.jpg

 

Now I have the H6 but the EA81 would be the same process. I can snap some underneath pics, and I need to do a how to write up......

Link to comment
Share on other sites

my little 4-banger rumbles. Subaru 4's can rumble, Honda 4's can't. I just took off the muffler and am running a 2" straight pipe right to the back. It has the perfect exhaust note, rumbly and bass-ey, but only loud when you punch it, and then you get a nice snarl and a 4 wheel spray of mud :headbang:

Link to comment
Share on other sites

Built my own 2" duals on my '82, using E.M.T. electrical conduit. For mufflers, I used Xcelerator Turbo Mufflers. Pipes exit just in front of the rear wheels.

Pics here. http://usmb.net/gallery/albuo81

Nice little Taka-Taka-Taka-Taka at idle. Sounds damn good when you nail the loud pedal. Nice mellow croon at hiway speeds.

May be due to it breathing even better now, but since the Weber install, the exhaust note has changed somewhat. But for the better in my opinion.

Hard time here, not nailing the loud pedal everytime I drive it. My 11 year old Son loves the sound too. 'Specially when he's riding in the back, "Come on Dad, Hit it!!!"

Ran her hard thru the gears afew times, come around a corner or curve and people are outside. The look on their faces be priceless. "All of that, came from,...... THAT!"

I have the only BRAT in the area, so most people are taken-back with just the vehicle itself, the exhaust really gets them.

No hassles from the Cops, yet. Did have one follow me across town, and all the way home once. This was after I nailed it to beat traffic, as I was coming out of the pizza joint. Heavily travel 4-lane street, during high traffic flow.

 

PS. Nice mud bath on that BRAT Scott!!!

Link to comment
Share on other sites

On my 86 Brat "Snow Worries",I cut the factory "J" pipes off and added two "seat of pants" to make the "X".

This allows the "X" to be placed at the point in the cross member where the factory pipe was.

Pretty quiet as it exits the rear, very nice non "buzz bomb"rumble.

Material - 2" Aluminized exhaust pipe

Has Weber DGEV32/36, and has been known to get out of it's own way. Both low end torque and high end HP increased as well as the MPG. Kinda of a "win-win-win" if you like.

duelexh.JPG

I second Tom -nice "mud up" Scott

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...