mcbrat Posted August 28, 2007 Share Posted August 28, 2007 one side broke, and I've added rear coilovers, and the side with the torsion bar (clocked too) is making it a bit too high... the bolt that holds the arm in snapped off.... Link to comment Share on other sites More sharing options...
TheSubaruJunkie Posted August 28, 2007 Share Posted August 28, 2007 Im sure you could disable it with a cutting torch Link to comment Share on other sites More sharing options...
ezapar Posted August 28, 2007 Share Posted August 28, 2007 one side broke, and I've added rear coilovers, and the side with the torsion bar (clocked too) is making it a bit too high... the bolt that holds the arm in snapped off.... So no un-clocking it? Just do the opposite of putting it up a notch. Link to comment Share on other sites More sharing options...
j2coe Posted August 28, 2007 Share Posted August 28, 2007 drill it and retap? if you want to put another one on later. otherwise there's always the ol' hacksawzzz Link to comment Share on other sites More sharing options...
mcbrat Posted August 28, 2007 Author Share Posted August 28, 2007 So no un-clocking it? Just do the opposite of putting it up a notch. not without that bolt I can't get a drill centered on the bolt remains to drill it out... I'm gonna check and see if I can get to it through the adjuster under the bed... actually, if I cut the adjuster off, that would do the trick .... hmmm.... Link to comment Share on other sites More sharing options...
j2coe Posted August 28, 2007 Share Posted August 28, 2007 sometimes you can start your center hole with a small bit to drill it out. it won't get moved around like a big bit. don't go deep just enough to make a pit that a bigger bit can hold till its past the rough surface. Link to comment Share on other sites More sharing options...
Phizinza Posted August 29, 2007 Share Posted August 29, 2007 sometimes you can start your center hole with a small bit to drill it out. it won't get moved around like a big bit. don't go deep just enough to make a pit that a bigger bit can hold till its past the rough surface.Also using a punch to make a dent in the bolt (or whatever your drilling) for the drill bit to follow. Works 9 times out of 10 for me.. Link to comment Share on other sites More sharing options...
mcbrat Posted August 30, 2007 Author Share Posted August 30, 2007 aaaggghhh, bolt is drilled out, but it still won't budge.... I may end up leaving it as is, and just get a diff drop plate..... Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now