dfoyl Posted September 8, 2007 Share Posted September 8, 2007 I'm working on retrofitting SPFI to my EA81 Brumby (Brat), and one of the pre-requisites is hooking up the o2 sensor for feedback. Problem is, we didn't get any EA81 or EA82 vehicles down under with SPFI, only MPFI on late (1990+) 2wd sedans. Does anyone have a photo of where the factory position for the o2 sensor goes on a EA81 with the US-fitted feedback carb setup ? I don't believe I can fit a MPFI L-series exhaust setup to an Brat, but if anybody's done it I'd be glad to hear from them! TIA. Dean. Link to comment Share on other sites More sharing options...
GeneralDisorder Posted September 8, 2007 Share Posted September 8, 2007 I have an EA82 y-pipe on my Brat - had to grind some on the cat's heat shield to make it fit but otherwise it's fine. Alternatively you could just put an O2 bung at the crotch of the y-pipe - that's where they are on SPFI's. GD Link to comment Share on other sites More sharing options...
dfoyl Posted September 9, 2007 Author Share Posted September 9, 2007 >>I have an EA82 y-pipe on my Brat - had to grind some on the cat's heat shield to make it fit but otherwise it's fine. Thanks GD! Dean. Link to comment Share on other sites More sharing options...
jono Posted November 1, 2013 Share Posted November 1, 2013 I am guessing by now you may have worked out a Y pipe off an mpfi L Series will have an O2 sensor and fits in a Brumby. I've done it recently now just needa reader to go with it. Dean, did you give up or is Tweetys set up excess to your requirements ? Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now