mudduck Posted September 22, 2007 Share Posted September 22, 2007 Got a 92 Legacy Awd wagon that seems to want to pull to the right. The wheel seems to be pulsing and pulling to the right. Air pressure is the same in all 4 tires, wheel bearings all checked out ok, and the rack and pinion steering seems ok with the exeption of a ripped boot that will be fixed. The alignment seems all good also, and the tires are about new. Tie rod ends and ball joints seem alright too. Could it be that the camber is off? Any ideas would be appreciated. Link to comment Share on other sites More sharing options...
nipper Posted September 22, 2007 Share Posted September 22, 2007 Pulsing. Frozen/stuck caliper and warped rotor? nipper Link to comment Share on other sites More sharing options...
mudduck Posted September 22, 2007 Author Share Posted September 22, 2007 No pusating in the pedel when the brakes are applied, whitch makes me thing rotors are ok. Link to comment Share on other sites More sharing options...
nipper Posted September 22, 2007 Share Posted September 22, 2007 Not necassarily. Mine would do it only above 70 mph in the break pedal. As long as your checking the calipers, check the rotors. (i replaced my rotors and it went away). nipper Link to comment Share on other sites More sharing options...
ericem Posted September 23, 2007 Share Posted September 23, 2007 Maybe a CV? Could be the tires still like they are out of balance or a belt broke. Doesn't hurt to check the calipers and make sure the sliders slide Link to comment Share on other sites More sharing options...
Kilroy Posted September 23, 2007 Share Posted September 23, 2007 Could be the camber, I just did some work on the halfshaft and when I put the camber bolt back in I had forgotten to mark it's location. So I tightened it up and took it for a drive and it pulled right, I rotated the bolt and retightened it and the pull was gone. Link to comment Share on other sites More sharing options...
nipper Posted September 23, 2007 Share Posted September 23, 2007 Could be the camber, I just did some work on the halfshaft and when I put the camber bolt back in I had forgotten to mark it's location. . Bad kilroy no biscuit. nipper Link to comment Share on other sites More sharing options...
heartless Posted September 23, 2007 Share Posted September 23, 2007 the pulsing when applying the brakes is either a warped rotor, or the ABS system... I feel the pulsing of the ABS system on my 90 Leg Wagon, but not to extreme - if it is excessive would definitely be checking the rotors... Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now