viceversa Posted December 9, 2003 Share Posted December 9, 2003 My heat only works when the selector is on "3". 1 and 2 do not blow anything. Looks like an electrical problem with the speed selector module (whatever it is called)? I have a spare one in my parts car but cannot figure how to disconnect the wires. Link to comment Share on other sites More sharing options...
gravelRX Posted December 9, 2003 Share Posted December 9, 2003 This has been covered numerous times. try the search function. Top right of your screen. Jay Link to comment Share on other sites More sharing options...
GeneralDisorder Posted December 9, 2003 Share Posted December 9, 2003 It's not your speed selector - it's the resistor block. Grab one from a JY that isn't burned out. GD Link to comment Share on other sites More sharing options...
viceversa Posted December 9, 2003 Author Share Posted December 9, 2003 Got it. I have one in a parts car. Here is the super long thread on that matter To check and or replace the resistor block- look under the glove box toward the fire wall and up The resistors sit in the air stream of the heater duct and the unit is held with three screws Two of which are obvious the third is one one of the motor mount screws. The wire colors are blue, blue/blk, blue/yel and blue/white. Last time I checked the dealer wanted about 60 bucks for a new one. The blower switches themselves do go bad but it is more likely the resistor block. Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now