archemitis Posted October 13, 2007 Share Posted October 13, 2007 my rear u joint is bad on my xt6 so im running it in front wheel drive for a while untill i come up with a good solution. the u joint is "staked" basicaly its held in with about 10 little hits with a punch to hold the cups into the driveshaft. parts books at parts stores dont list one since subaru wanted you to replace the whole drive shaft if it ever failed. so i did some measuring and i think i found a u joint for another car that will fit... but has anyone ever done this? any part numbers? thanks Link to comment Share on other sites More sharing options...
idosubaru Posted October 13, 2007 Share Posted October 13, 2007 rockford sells ujoints specifically for the XT6. i have a complete set installed in mine. dont know the part numbers but i've posted them on here and at the XT site before. they are rather steep - $20 or $30 each. easiest solution is to just get a used one. if it's the rear portion then ANY EA82 or ER27 rear half shaft will work. i probably have one i could send you...as do tons of others here on the board. Link to comment Share on other sites More sharing options...
TomRhere Posted October 14, 2007 Share Posted October 14, 2007 430-10 is their number for the u-joint. Here's the link.... http://www.rockforddriveline.com/New%20Parts%20Page/Staked%20In%20Page.pdf Link to comment Share on other sites More sharing options...
operose Posted October 14, 2007 Share Posted October 14, 2007 these dudes know what's up. I'm running a "gary's special" rear driveshaft in my xt6 right now Link to comment Share on other sites More sharing options...
mykingcrab Posted October 14, 2007 Share Posted October 14, 2007 Dont let those stake marks spook ya. just use a strong vise and start driving them out. easy as pie. Just act likethey are not even staked.I already practiced on a rear half that NUG gave me with the RX,and it was pretty easy.Ive got new ones ready for Roxy.and plan on doing them both as soon as i get home. Ill take some good digital photos and document the process. Link to comment Share on other sites More sharing options...
archebald23 Posted September 28, 2010 Share Posted September 28, 2010 hi there.how were you able to replace your driveshafts and u joints? thanks Link to comment Share on other sites More sharing options...
GeneralDisorder Posted September 28, 2010 Share Posted September 28, 2010 What is it with you and three year old threads dude? Most of these people don't hang around here much anymore..... Why not just start a thread and ask your question? Bad form. GD Link to comment Share on other sites More sharing options...
Recommended Posts
Please sign in to comment
You will be able to leave a comment after signing in
Sign In Now