Jump to content
Ultimate Subaru Message Board

Brake light on dash


cd45
 Share

Recommended Posts

The light on the dash of the Brat that is supposed to warn you that you are low on brake fluid comes on every time I step on the brake pedal. I have thouroughly gone through the brake system, even replaced all the fluid. Is the problem with the sensor in the top of the resevoir? Can I just run a wire between the two on the top, or will that really mess things up? I am not worried about running out of brake fluid, I religously check all the fluids under the hood 2 or 3 times a week. I know the system is good, just worried about the light on the dash. Any help is good. Thanks.

Link to comment
Share on other sites

Unlike other cars these are fairly reliable switches.

 

I dont remeber, but you may have a much bigger issue, as in dont drive the car till you find it.

 

The brake light switch used to be for fluid level AND brake line pressure. If there is an imbalance between the left and right sides of the brake system, the light will come on.

 

Unplug the connector for the fluid level switch. If the light goes away you found your problem

 

If the light is still there, check the altenator output with your foot on the brake pedal. A bad altenator will illuminate the brake light.

 

If that checks out you have to look deeper into the system.

 

nipper

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...