Jump to content
Ultimate Subaru Message Board

91 AWD weird feeling when making a tight turn...


Recommended Posts

okay - yet another new problem with my legacy - when making a tight turn, like in to a parking place, it makes a weird dragging,binding kind of a vibration in the front end - I'm thinking that this is not good....

 

any suggestiions much appreciated...

Link to comment
Share on other sites

Is this a manual trans or auto trans? If it is torque bind, common causes are

(a) running with tires where the circumferences are not all within 1/4"

(B) running with a soft/flat tire for a period of time

© improper towing

 

Sometimes clicking in turns though is cv joints.

Link to comment
Share on other sites

I would want to rule out a bad CV joint first.

 

Do you ever hear / feel a clacking when stepping on the gas in a turn?

 

Look behind the wheel hubs and see it there is evidenece

of grease being thrown out of a torn CV boot.

 

 

If not, you could be in the early stages of Torque Bind.

 

Fist thought is to have the tranny fluid changed via a flush.

(some like to do the multiple pan drain and fills,

I like it all in one shot)

 

The repair is not fun, it involves removing the tail shaft of the tranny.

It can be done with the tranny in the car but...

peak under there once to get an idea of what is involved.

 

Hope this gives you some insight.

Link to comment
Share on other sites

Don't panic yet. Check the CVs, just in case, especially if there's clicking.

 

The fluid that can be replaced and might be helpful is ATF. As Skip has already mentioned, a complete change (flush) sometimes is the cure.

 

A bad VLSD (assuming your car has one) could also cause certain binding symptoms, but it's not the first thing to consider.

Link to comment
Share on other sites

"Torque bind" occurs when the transfer clutches

that engage the rear drive lock up when they

shouldn't.

 

This puts the car in 4wd like a truck or Jeep with 4wd

engaged.

 

These have no center differential so turning

(which causes the wheels to traverse different

distances) causes the drive train bind.

Like one would feel in a truck with 4wd engaged

used on dry pavement.

 

Causes for this lock up vary but usually

it can be attributed to the fact that

the solenoid (called solenoid C )

in the tailshaft has failed.

 

This solenoid (when working) opens the drain for the hyd.

pressure that holds the clutches locked.

The amount of "drainage" is controlled by

the TCU (Transmission Control Unit) by

sending a duty cycle signal to solenoid C.

Thus controlling the "percentage" of drive

sent to the rear wheels.

 

 

If the solenoid fails, the hyd pressure is

NOT drained and therefore forces the

clutches to lock the rear drive "In".

 

You are now in "locked" 4wd.

 

 

 

I am sure someone will chime in and fill in details I

overlooked or stated incorrectly.

Hope this helps understand your Subaru AWD system.

Link to comment
Share on other sites

Well i see my work here is done :)

 

Yes its TB.

 

Change the fluid first to see if it can help, but the older and higher the mileage on the car, the more likely it is to be a tired clutch pack.

 

Try the lucas additive that people like. That may free it up, someone will tell you exaclty which one. Its like chicken soup, it cant hurt.

 

Its not only the duty C that can make it happen, but it can also be old tired sticky clutches.

 

nipper

Link to comment
Share on other sites

I'm still not clear on if you can have TB in an auto trans....

Yes, the discussion thus far has been for the auto trans

A.K.A. 4EAT (4 speed Electronic Automatic Transmission)

 

Manual trannys use a different system.

 

I'm going to start with a fluid check -

 

should I run some sea foam or something through it?

 

I'll check the boots as well.

Changing, rather than checking is the recommended procedure.

No Seafoam is not what is suggested (I didn't know they

recco'd it for automatics - I'll look)

 

Nipper mentions

Lucas tranny conditioner.

Available at most parts stores

3157VA33ZCL._SS400_.jpg

Link to comment
Share on other sites

Big - That's been my solution so far - just go straight!:rolleyes:

 

Thanks for the clarification, Skip -

 

Could the extreme cold weather have brought on these symptoms?

 

Torque bind needs to be investigated, as very little driving is straight. It doesnt magically go away in slick weather. what happens is that the wheels can more easily brake loose at the wrong time, and then if your really unlucky, you get to be close up and personal with another object. It will just get worse with time.

 

If the cold weather bought on these synptons, all the more reason to change the fluid to see if it goes away. It means that your tranny fluid is very old and gummy.

 

Have you tried the FWD fuse holder trick to see if it goes away?

 

nipper

Link to comment
Share on other sites

UPDATE:

Okay- fresh tranny fluid and 1/2 a bottle of lucas additive didn't make a difference...

 

I did disable the AWD and in FWD mode it didn't have a problem in a tight turn. Also, no CV boots torn on any of the 4 wheels that I can see or feel...

 

Am I screwed yet?:-\

Link to comment
Share on other sites

You are at the exact point I was at a year ago (only I had a '93) :-p

 

I changed my fluid like you did, and it didnt help much.

I drove to avoid the tight turns like you are... and it sorta helped :-\

I put the FWD fuse in the holder... and that helped a lot. (for a while)

 

I ended up removing the rear drive shaft for the spring/summer , as after a while, it began ignoring the fuse. ...and binding anyway.

:mad:

 

Worst case scenario ... put a j/y tranny in it that has low miles. :eek:

Link to comment
Share on other sites

UPDATE:

Okay- fresh tranny fluid and 1/2 a bottle of lucas additive didn't make a difference...

 

I did disable the AWD and in FWD mode it didn't have a problem in a tight turn. Also, no CV boots torn on any of the 4 wheels that I can see or feel...

 

Am I screwed yet?:-\

 

Drive in FWD mode, it makes the car more stable to drive. you dont have a duty C problem, you have a clutchpack problem.

 

you can either save money a- for a used tranny, or b - rebuild the clutch pack.

 

i dont remeber, but i am assuming all your tires match and are equally worn.

 

nipper

Link to comment
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
 Share

×
×
  • Create New...